Samsung SDC-415 instruction manual Connecting to a monitor, Connecting to power

Page 10

Installation

Connecting to a monitor

Please connect the video output terminal located on the back of the camera to the monitor.

CCD Camera

Monitor

The connection method varies depending on the type of monitor and accessories. Please refer to the user's manual for each instrument.

Please turn off the power when connecting.

Please select Hi-Z on the 75/Hi-Z switch for the intermediate video TV set and select 75for the Intermediate device as shown in the picture below.

CCD Camera

Intermediate

End monitor

Connecting to power

Each model has a different power input specification.

Please check the model type and standard power requirement before connecting to power.

AC Power Type (AC 24V, 500mA)

DC Power Type (DC 12V, 500mA)

The recommended adaptor specification for SDC-415NA/ SDC-415PA is AC 24V, 500mA and the recommended adaptor specification for SDC-415ND/ SDC- 415PD is DC 12V, 500mA.

An adaptor that meets the standard requirement must be used.

When the resistance value of copper wire is at [20°C(68°F)]

Copper wire size(AWG)

#24(0.22mm2)

#22(0.33mm2) #20(0.52mm2)

#18(0.83mm2)

Resistance value(/m)

0.078

0.050

0.030

0.018

Voltage drop(V/m)

0.028

0.018

0.011

0.006

As shown in the table above, voltage decreases as the wire gets longer.

Therefore use of an excessively long adaptor output line for connection to the camera may affect the performance of the camera.

Standard voltage for camera operation : DC 12V±10%

There may be some deviation in voltage drop depending on the type of wire and the manufacturer.

COLOR CCD CAMERA 18 User’s Manual

COLOR CCD CAMERA 19 User’s Manual

Image 10
Contents SDC-415 Series Signal System Ssnr Samsung Super Noise Reduction Horizontal Resolution 530 TV LinesHigh Sensitivity Electronic IrisContents Precautions Them to physical shocks Strong light directlyFront ComponentsNames and Functions of Parts Auto iris lens connection plug Mount adaptorSide Auto iris lens connectorMounting bracket screw hole Back InstallationWhen using an auto iris lens LensWhen using a C-Mount lens When using a CS-Mount lensConnecting to power Connecting to a monitorAC Power Type AC 24V, 500mA DC Power Type DC 12V, 500mA Camera Operation SettingsMenu Lens selection DC/VIDEO Auto iris lens selectionShutter condition and speed control White Balance controlBACKLIGHTBacklight Compensation AGC Auto Gain ControlSsnr Samsung Super Noise reduction Sens UP Low illuminanceSpecial Color Exit Troubleshooting Problems TroubleshootingSpecifications SDC-415NA SDC-415ND SDC-415PA SDC-415PDMemo