Samsung SDC-415 instruction manual When using a C-Mount lens, When using a CS-Mount lens

Page 9

Installation

3.Please remove the cover of the auto iris lens connection plug and solder the lens cable to the connector pin in the plug.

Pin No.

 

LENS

DC

VEDIO

 

No.1 Pin

Damping-

Red(power)

No.2 Pin

Damping+

NC

No.3 Pin

Drive+

White(video signal)

No.4 Pin

Drive-

Black(GND)

 

 

Lens cable

No.3 Pin

 

 

No.1 Pin

 

Connector

No.4 Pin

No.2 Pin

4.Please replace the auto iris lens connection plug cover and take off the lens protection cap, and then attach the auto iris lens to the camera by screwing it in clockwise.

5.Please insert the connection plug that is connected to the auto iris lens cable into the auto lens connector, which is located on the side of the camera.

When using a C-Mount lens

Please take off the lens protection cap and attach the C-Mount lens to the camera by screwing it in clockwise.

C-mount adaptor

When using a CS-Mount lens

1. Please take off the lens protection cap and C-mount adaptor.

C-mount adaptor

Lens protection cap

2. Please attach the CS-Mount lens to the camera by screwing it in clockwise.

C-mount adaptor

Note

Please use the specified lens connection parts as shown in the picture below. The use of the wrong sized parts of the wrong size may cause

damage to the inside of the camera or result in poor fitting.

6. Please set the lens selection switch, located on the side of the camera, to DC or VIDEO depending on the type of auto iris lens which is being used.

Use of a lens which is too heavy affects the balance of the camera and may cause a malfunction. Please use a lens that weighs less than 450g.

Please select Av mode if possible when adjusting the automatic light control (ALC) of an auto lens. Use of PK mode may cause hunting.

C-mount lens : 10 mm or less

CS-mount lens : 5 mm or less

COLOR CCD CAMERA 16 User’s Manual

COLOR CCD CAMERA 17 User’s Manual

Image 9
Contents SDC-415 Series Signal System High Sensitivity Horizontal Resolution 530 TV LinesSsnr Samsung Super Noise Reduction Electronic IrisContents Them to physical shocks Strong light directly PrecautionsNames and Functions of Parts ComponentsFront Auto iris lens connection plug Mount adaptorAuto iris lens connector SideMounting bracket screw hole When using an auto iris lens InstallationBack LensWhen using a CS-Mount lens When using a C-Mount lensConnecting to a monitor Connecting to powerAC Power Type AC 24V, 500mA DC Power Type DC 12V, 500mA Settings Camera OperationMenu DC/VIDEO Auto iris lens selection Lens selectionWhite Balance control Shutter condition and speed controlAGC Auto Gain Control BACKLIGHTBacklight CompensationSens UP Low illuminance Ssnr Samsung Super Noise reductionSpecial Color Exit Problems Troubleshooting TroubleshootingSDC-415NA SDC-415ND SDC-415PA SDC-415PD SpecificationsMemo