B&K CT300, CT600, CT602, CT310, CT610 user manual Zone Power On Settings, Page/Event Setup

70 Audio / Video Submenu

				Zone Power On Settings
			1.	Use Left/Right to select a zone to setup for power on set-
	Z11 Zone A	POWER ON
1	Audio	Last Used		tings. Then use up/down to select an item to adjust. Use
				Left/Right to adjust the item selected.
2	Video	Last Used
3	Volume	Last Used	2.	When the selected zone is powered on, how do you want
4	Bass	Last Used		the zone to come up? This is where you can select turn
5	Treble	Last Used		on input, turn on volume, turn on bass, treble, loudness,
6	Loudness	Last Used		etc. Every time you turn on this zone it will “Power On”
	SEL toggle last used			to specific predetermined setting. Last used will allow the
	↑↓ next item	adjust ←→		zone to turn on exactly how it was turned off, i.e. input,
	MENU main menu
				volume, etc...

Page/Event Setup

SETUP PAGE/EVENT 1

1	Action	Switch to 8
2	Activated by	Control 1
3	Level	-46dB
4	Turn off delay	5sec
5	Affects Control Out
	and Flasher Out	No

1.Use Left/Right to select which Page/Event to setup. Then use up/down to select an item to adjust. Use Left/Right to adjust.

2.When the EVENT happens what should the affected zone(s)* do? The zone can switch to any shared input, change volume, mute, etc.

↑↓ next item adjust ←→

MENU setup A/V

*Note: Only Zones which have been setup under the Zone(s) Menu to respond to Page/Event 1 or 2 or Both will be affected by the Setup Page/Event screen. Page/Events are described on page 22.

		Zone Sync Setup
Z11 ZONE A	ZONE SYNC
1 Changes	relative 1.	Use Left/Right to select which zone or group of zones to
		setup. Then use up/down to select changes. Use
when changing volume bass		Left/Right to adjust between relative and absolute.
and treble - linked zones*		Relative: all volumes change relative to one another.
will change relative to		Absolute: All volumes sync to same volume level before
their current levels		change is made, referenced from the zone the command
↑↓ next item	adjust ←→	is received from.
MENU setup A/V		*Note: The expression "linked zones" means the hard-
		ware zones that make up a code-set group (i.e. the

logical zone "Downstairs" consists of the hardware zones B - “Dining Room”, C - “Kitchen”, and D - “Patio”).

B & K

S I M P LY B E T T E R !