Operating Your Camera
V-REV:
IMAGE ADJ: Includes image quality or special function factors.
•TONE | : Increasing this value increases the overall brightness. |
•SHARPNESS : Increasing this value sharpens object edges. Too high of a setting, however, produces noise and may obscure the image.
•COLOR : Adjusting this value affects the chroma level only; the burst level is unaffected.
COMMUNICATION: Use this feature to select communication protocol (refer to p.48~ p.53 for details). Position the indicator over 'COMMUNICATION' using the UP or DOWN button.
•CAM ID NO. : Assign an ID number to the camera (1 to 255).
Identification number zero is used for Remote controller setup.
•CAM ID DISP: Displays camera ID on top left corner of the screen.
•BAUD RATE : Configure baud rate from 9600, 19200, or 38400bps.
•UART MODE : Configure parity bit to NON, EVEN, or ODD. Data bit is set to 8bit, and stop bit to 1bit. Set the UART MODE to EVEN if using the Remote Controller.
•RETURN PACKET : Used to transfer a packet.
END: evert back to the USER PRESET menu.
RESET
To reset your camera to factory default condition.
EXIT
To finish setup menu.
COLOR CCD CAMERA 42 User’s Manual | COLOR CCD CAMERA 43 User’s Manual |