Silex technology SDZ-330 instruction manual Connecting to connection External Control Connector

Connection

Connecting to connection

External Control Connector

FOCUS (Input)

ZOOM (Input)

COM

MD (output)

Connector		Function			Signal Level						I/O
		Tele					+6V~+12V
ZOOM										COM	I
		Wide								COM
								-6V~-12V
		Far					+6V~+12V
FOCUS										COM	I
		Near								COM
								-6V~-12V
	COM									COM	-
									+4.0V~+5.0V
	MD			0V		5±0.5sec		There is motion			O
			There is no motion

*MD (Motion Detection) Output Signal Level (less than 10mA)

*When using the MD function, the 'GND' should be connected to the frame ground.

Communication Control Connector

The camera can be controlled by using external controllers like a Remote controller. (RS485 Communication)

SCC-3000	Remote Controller	6-Pin Connection
	SCC-100, SDZ-160CO	Cable

* Communication Control Connector Pin Description .

Number	Name	Description	Number	Name	Description
1	GND	-	4	TRX +	RS-485 Communication
2	EXT.SYNC	External ‘SYNC’ Signal	5	TRX -	RS-485 Communication
3	GND	-	6	Output Power	Remote Controller only

* EXT. SYNC		3V or 5V
	Min: 500ns	0V

60Hz ± 0.1Hz(NTSC), 50Hz ± 0.1Hz(PAL)

*Communication Setting can set the communication setting as shown in the table below. When you use to connect SCC-100 or SCC-3000, the default sets for SCC-100.

ITEM	SCC-100	SCC-3000
MODE	Serial	Serial
Data Bit	8 bit	8 bit
Bit/Sec	9600bps	9600bps
Parity	EVEN	NON
CAM ID NO.	0	1~255
RETURN PACKET	ENABLE	See the SCC-3000 settigs

Notes

• Contact an authorized technician for inspection.

COLOR CCD CAMERA 16 User’s Manual COLOR CCD CAMERA 17 User’s Manual