Planar UltraRes Remote Monitoring Software
Date and Time
Use this page to change date and time information as needed.
1Set the date and time manually in the box under the Manual Date and Time section. The date format is very exact. Fill in the current date and time using exactly the format shown on the page. Click Set date and time.
2If you want to have the server periodically check the time from a network source, fill in the NTP server name or address, and poll interval in the Date and Time Server section. Click Apply new date and time server settings.
Note: If you don’t have a preferred NTP server, then www. pool.ntp.org is a reasonable choice for most installations.
3Carefully read the instructions in the Local Time Zone section. Fill in the text box and click Set time zone.
Note: The start and end of daylight saving time default to the first Sunday of April and the last Sunday of October. As of 2007, U.S. locales that observe daylight saving time must enter start and end dates in this section. For example, EST5EDT,M3.2.0,M11.1.0 is correct for U.S. Eastern time zone as of 2007.
Planar UltraRes User Manual | 69 |