LOREX Technology LW2702 instruction manual Screen Saver Mode, Screen Saver menu

Screen Saver Mode

Use the Screen Saver mode to conceal the fact that the LCD receiver is actually a surveillance recorder. The system comes pre-loaded with five scenic images that let the LCD receiver simulate a picture frame. When motion is detected by a camera, the LCD receiver will display the triggered camera in single channel full-screen.

NOTE: The images are loaded to the system firmware, not the SD card. Formatting the SD card will not delete the Screen Saver images on the system.

To enable Screen Saver mode:

1.Press the MENU button to open the Main Menu.

2.From the Main Menu, select Setting and press the Enter button.

3.From the Settings menu, select Screen Saver and press the Enter button.

4.From the Screen Saver menu, select Blank screen or Picture 1~5 and press the Enter button.

NOTE: Select “Blank Screen” as a power

saving option. Figure 5.3 Screen Saver menu

5.Press the MENU button until all menu windows are closed.

6.Press the Scan/Del button to activate Screen Saver Mode. One of the selected images will appear on the LCD receiver and “SCAN” will light up on the bottom of the LCD receiver.

7.Press the Scan/Del button again to disable Screen Saver mode.

NOTE: The system will be in Auto Sequence mode when Screen Saver mode is disabled.

SCAN

Figure 5.4 Press the Scan/Del button to turn on the Screen Saver

23