Vivotek 4X-IP7142 manual Preset Position, Custom Command

Page 48

VIVOTEK - A Leading Provider of Multimedia Communication Solutions

Preset Position

Click Preset Position to open the Preset Position page. In this page, you can set the preset position for the Network Camera. A total of 20 preset positions can be conﬁgured.

Follow the steps below to set preset positions:

1.Adjust the Network Camera to a desired position with the buttons on the right side of the window.

2.In the Preset position name text box, enter a descriptive name for the preset position. The preset position name allows up to forty characters. Click Add to take effect. The preset position name will appear in the Preset Positions drop-down list. To remove a preset position from the list, select a preset position name from the Preset Positions drop-down list and then click Delete.

3.You can click “Go to” to aim at preset positions, which will also displayed in the main page.

4.Click Save to take effect.

Custom Command

If the Custom camera (scanner) is selected as the PTZ driver, the PTZ control panel on the main page will not take effect. You need to conﬁgure command buttons to control the

PTZ scanner. Click Custom Command to open the Custom Command page. A total of ﬁve command buttons can be conﬁgured. Please refer to the user's manual of your PTZ scanner to enter the command in the following blanks.

Click Save to enable the settings and click Close to quit the page.

48 - User's Manual

Image 48

Contents Page Table of Contents Package contents Read before useConnectors Physical descriptionDI/DO Diagram Hardware installation Hardware ResetWall mount Ceiling mount Ethernet switch Network deploymentInternet connection with static IP Set up the Network Camera through Power over Ethernet PoE Software installation 0002D17142ADAccessing the Network Camera Using web browsersPage Using Rtsp players Using 3GPP-compatible mobile devices MPEG-4Using Vivotek recording software Main Live Video Window Video title Title and time Client Settings MP4 Saving Options System SystemSystem Time DI and do Root Password SecurityAdd User Manage UserEnable Https Create and Install CertiﬁcateTo create a self-signed certificate Certificate Information Network Network TypePPPoE Point-to-point over Ethernet Page Http Https Two way audioFTP Rtsp Streaming Page Ddns Dynamic domain name service DdnsCustomSafe100 Access list Allowed list / Denied listDelete allowed list / Delete denied list Video settings Audio and videoImage Settings Privacy mask Page Page Audio settings To enable motion detection, follow the steps below Motion detectionPercentage = 30% RS485 Settings Camera controlPreset Position Custom CommandNetwork Camera Media Settings ApplicationSnapshot20080104100341 Server Settings Page Page Event Settings Page Recording Settings RecordingPage System log Remote LogCurrent Log View parameters Maintenance RebootRestore Upload / Export Daylight Saving Time Conﬁguration File Upgrade Firmware Page URL Commands of the Network Camera OverviewStyle convention General CGI URL syntax and parameters Security levelGet server parameter values Method GET/POSTSet server parameter values Page Available parameters on the server Timezoneindex 489 ~ Group dii0~ndi-1 Group doi0~ndo-1Group security Subgroup of network httpSubgroup of network https Subgroup of network rtspSubgroup of network pppoe Group ipfilter Page Page Adjust saturation of image according to mode settings Group upnppresentation Group upnpportforwarding= Logalert = Logcrit Even Group uarti0~n-1 n is uart port countGroup capability Group eventi0~2 Group serveri0~4 Group mediai0~4 Group recordingi0~1To enable or disable this recoding Drive the digital output Query status of the digital inputQuery status of the digital output Capture single snapshotAccount management Upgrade ﬁrmware System logsSystem Information Method PostIP ﬁltering Method GET/POSTGet SDP of Streamings Open the network streamingsSenddata Page Technical Speciﬁcations LensTechnology License Notice Electromagnetic Compatibility EMC