Vivotek 4X-IP7142 manual Hardware installation, Hardware Reset

Page 6

VIVOTEK - A Leading Provider of Multimedia Communication Solutions

Hardware Reset

Reset button

Status LED

There is a reset button on the inner side of the Network Camera. It is used to reboot the Network Camera or restore the Network Camera to factory default. Sometimes rebooting the Network Camera could set the Network Camera back to normal state. If the problems remain after rebooted, restore the Network Camera to factory default and install again.

Reboot: Press and release the reset button. The status LED will blinks two short one long in red.

Restore: Press the reset button continuously for over 5 seconds until the status LED blinks two short one long in red. Note that all settings will be restored to factory default.

Installation

Hardware installation

Follow the steps below to install the Network Camera:

1.Open the lens cover.

2.Secure the Network Camera to the wall/ceiling by the supplied camera stand.

1	2

3.Feed power to the Network Camera and connect it to the Internet. For more information, please refer to Network deployment on page 8 for details.

6 - User's Manual

Image 6

Contents Page Table of Contents Package contents Read before useConnectors Physical descriptionDI/DO Diagram Hardware installation Hardware ResetWall mount Ceiling mount Ethernet switch Network deploymentInternet connection with static IP Set up the Network Camera through Power over Ethernet PoE Software installation 0002D17142ADAccessing the Network Camera Using web browsersPage Using Rtsp players Using 3GPP-compatible mobile devices MPEG-4Using Vivotek recording software Main Live Video Window Video title Title and time Client Settings MP4 Saving Options System SystemSystem Time DI and do Add User Root PasswordSecurity Manage UserEnable Https Create and Install CertiﬁcateTo create a self-signed certificate Certificate Information Network Network TypePPPoE Point-to-point over Ethernet Page Http Https Two way audioFTP Rtsp Streaming Page Ddns Dynamic domain name service DdnsCustomSafe100 Access list Allowed list / Denied listDelete allowed list / Delete denied list Video settings Audio and videoImage Settings Privacy mask Page Page Audio settings To enable motion detection, follow the steps below Motion detectionPercentage = 30% RS485 Settings Camera controlPreset Position Custom CommandNetwork Camera Media Settings ApplicationSnapshot20080104100341 Server Settings Page Page Event Settings Page Recording Settings RecordingPage System log Remote LogCurrent Log View parameters Maintenance RebootRestore Upload / Export Daylight Saving Time Conﬁguration File Upgrade Firmware Page URL Commands of the Network Camera OverviewStyle convention Get server parameter values General CGI URL syntax and parametersSecurity level Method GET/POSTSet server parameter values Page Available parameters on the server Timezoneindex 489 ~ Group dii0~ndi-1 Group doi0~ndo-1Group security Subgroup of network httpSubgroup of network https Subgroup of network rtspSubgroup of network pppoe Group ipfilter Page Page Adjust saturation of image according to mode settings Group upnppresentation Group upnpportforwarding= Logalert = Logcrit Even Group uarti0~n-1 n is uart port countGroup capability Group eventi0~2 Group serveri0~4 Group mediai0~4 Group recordingi0~1To enable or disable this recoding Drive the digital output Query status of the digital inputQuery status of the digital output Capture single snapshotAccount management System Information Upgrade ﬁrmwareSystem logs Method PostIP ﬁltering Method GET/POSTGet SDP of Streamings Open the network streamingsSenddata Page Technical Speciﬁcations LensTechnology License Notice Electromagnetic Compatibility EMC