Edimax Technology PT-112E & MD-111E, PT-111E Appendix, Q1 Status led does not light up

Page 42

Network Camera User’s Manual

Appendix

A. Troubleshooting & Frequently Asked Questions

Q1: Status led does not light up.

A1: First, make sure thatConfiguration>System>Turn off the LED indicatoris disabled. If it is, check the item, and the led should light up. Second, if red led does not light up, please check that the power adapter in the package is plugged correctly. And last, if green led does not light up; please check that category 5 UTP cable is plugged correctly. If the problem is still not solved, please contact your dealer for further help.

Q2: What kind of Ethernet cable is used by network camera?

A2: The network Camera uses Category 5 UTP cable allowing 10 and/or 100 Base-T networking.

Q3: The Network Camera will be installed and work if a firewall exists on the network?

A3: There are two way to set up the IP camera at Internet.

(1) By UPnP Port Forwarding

1.Select an IP router. It must support UPnP port forwarding and enable this function first!!

2.Connect camera RJ45 cable to IP router and the router is also connected to Internet.

3.Plug power cord to camera.

4.Go to camera Network page. Enable UPnP port forwarding

5. Check camera status, we can see the ports had been successfully opened!

42/59

Image 42
Contents PT-111E / PT-112E & MD-111E Table of Contents Overview Minimum System RequirementPackage Contents Connections Wired cover Slide coverReset button Micro SD/SDHC Internal Microphone Light sensor LensHardware Installation Power over Ethernet PoE  Using a PoE-enabled switch Connect to the Network Camera Locate the IP address of Network IP CameraNetwork Camera User’s Manual Initial Access to the Network Camera Video will be displayed Configuration functions Primary user’s capabilityCamera view View capabilitiesPan/Tilt & connection control buttons PT-111E / PT-112E only Client Setting 16/59 LED indicator Definitions in ConfigurationGeneral Setting Host name System parametersDaylight saving Time Setting Time zoneAdjust by NTP server Current TimeSecurity setting SecurityManage user 20/59 LAN & PPPoE Network SettingNetwork LANDdns Setting Get IP address automatically Use fixed IP addressPPPoE 23/59 Access list Access list settingAudio and Video setting General SettingVideo Setting Infrared Led SettingAudio Setting Schedule mode Video recordSchedule information Record parameters 1NASStream Audio codec settingVideo codec setting Bit rateSnapshot and time display setting Camera control PT-111E / PT-112E only Camera controlPatrol list setting Application Sun/Mon/Tue/Wed/Thu/Fri/Sat Select the daysSnapshot & Record file setting Trigger modeMedia mode Response mode4NAS NAS server setting Storage StatusFile operation Syslog Status and Parameters Maintenance Export/Import file Appendix Q1 Status led does not light upQ2 What kind of Ethernet cable is used by network camera? 43/59 44/59 Q6 How can I restore the network camera to default value? Q12 The process of upgrade firmware abort Q7 I cannot play the recorded video fileQ10 The cover of network camera is warm. Is it normal? Camera from Internet Explorer A13Ip-discovery.comFree Ddns service 49/59 Current device Federal Communication Commission Interference Statement EU Countries Not Intended for Use EU Declaration of Conformity Weee Directive & Product Disposal 55/59 56/59 No Warranty 58/59 Network Camera User’s Manual 59/59