Edimax Technology PT-112E & MD-111E Q6 How can I restore the network camera to default value?

Page 45

Network Camera User’s Manual

3.Type IP address at browser. Then you can see camera through Internet.

4.You can also type the ddns name at below label of camera on browser URL field. For example, you may type ah00001.ip-discovery.com.

Note: The firewall software at PC may block the transfer of network camera. Please remove or stop the kind software.

Q4: How can I find the network camera in the local area network?

A4: By using the IP Finder2 program or using UPnP to find it.

Q5: IP Finder2 program cannot find Network Camera in the local area network at first time?

A5: Make sure the subnet of network camera is same as your PC. If the local area network supports DHCP, the camera is ―Get IP address automatically‖ in the ―Network‖ page default. If the local area network does not support DHCP, change your PC IP address to ―192.168.0.xxx‖.

Q6: How can I restore the network camera to default value?

A6: Use a gem clip to press on the inside button. Network camera begins to restore

45/59

Image 45

Contents PT-111E / PT-112E & MD-111E Table of Contents Minimum System Requirement OverviewPackage Contents Reset button Micro SD/SDHC Wired cover Slide coverConnections Internal Microphone Light sensor LensHardware Installation Power over Ethernet PoE  Using a PoE-enabled switch Locate the IP address of Network IP Camera Connect to the Network CameraNetwork Camera User’s Manual Initial Access to the Network Camera Video will be displayed Primary user’s capability Configuration functionsView capabilities Camera viewPan/Tilt & connection control buttons PT-111E / PT-112E only Client Setting 16/59 General Setting Host name Definitions in ConfigurationLED indicator System parametersAdjust by NTP server Time Setting Time zoneDaylight saving Current TimeSecurity setting SecurityManage user 20/59 Network Network SettingLAN & PPPoE LANDdns Setting Get IP address automatically Use fixed IP addressPPPoE 23/59 Access list setting Access listGeneral Setting Audio and Video settingVideo Setting Infrared Led SettingAudio Setting Schedule mode Video recordSchedule information 1NAS Record parametersVideo codec setting Audio codec settingStream Bit rateSnapshot and time display setting Camera control Camera control PT-111E / PT-112E onlyPatrol list setting Sun/Mon/Tue/Wed/Thu/Fri/Sat Select the days ApplicationMedia mode Trigger modeSnapshot & Record file setting Response mode4NAS Storage Status NAS server settingFile operation Syslog Status and Parameters Maintenance Export/Import file Appendix Q1 Status led does not light upQ2 What kind of Ethernet cable is used by network camera? 43/59 44/59 Q6 How can I restore the network camera to default value? Q12 The process of upgrade firmware abort Q7 I cannot play the recorded video fileQ10 The cover of network camera is warm. Is it normal? A13 Camera from Internet ExplorerIp-discovery.comFree Ddns service 49/59 Current device Federal Communication Commission Interference Statement EU Countries Not Intended for Use EU Declaration of Conformity Weee Directive & Product Disposal 55/59 56/59 No Warranty 58/59 Network Camera User’s Manual 59/59