Edimax Technology PT-112E & MD-111E, PT-111E user manual Export/Import file

Page 41

Network Camera User’s Manual

4. “Export/Import file”

--Export setting backup file: Click to export all parameters for the device and user-defined scripts.

--Upload setting backup file: Click Browse… to upload a setting backup file. Please note that the model and firmware version of the device should be the same as the setting backup file. If you have set up a fixed IP or other special settings for your device, it is not suggested to upload a settings backup file.

5. “Upgrade firmware” Select the firmware file and click upgrade button. Please be aware that you should not turn off the power during updating the firmware and wait for finish message.

Warning: The upgrade firmware procedure cannot be interrupted. If the power and/or network connection are broken during the procedure, it might possibly cause serious damage to the Network Camera.

Note: When upgrade firmware please wait for 90~210 seconds, and then you can connect to Network Camera again. The system will restart and require the installer program to set up the network again.

41/59

Image 41

Contents PT-111E / PT-112E & MD-111E Table of Contents Minimum System Requirement OverviewPackage Contents Reset button Micro SD/SDHC Wired cover Slide coverConnections Internal Microphone Light sensor LensHardware Installation Power over Ethernet PoE  Using a PoE-enabled switch Locate the IP address of Network IP Camera Connect to the Network CameraNetwork Camera User’s Manual Initial Access to the Network Camera Video will be displayed Primary user’s capability Configuration functionsView capabilities Camera viewPan/Tilt & connection control buttons PT-111E / PT-112E only Client Setting 16/59 General Setting Host name Definitions in ConfigurationLED indicator System parametersAdjust by NTP server Time Setting Time zoneDaylight saving Current TimeManage user Security settingSecurity 20/59 Network Network SettingLAN & PPPoE LANPPPoE Ddns SettingGet IP address automatically Use fixed IP address 23/59 Access list setting Access listGeneral Setting Audio and Video settingAudio Setting Video SettingInfrared Led Setting Schedule information Schedule modeVideo record 1NAS Record parametersVideo codec setting Audio codec settingStream Bit rateSnapshot and time display setting Camera control Camera control PT-111E / PT-112E onlyPatrol list setting Sun/Mon/Tue/Wed/Thu/Fri/Sat Select the days ApplicationMedia mode Trigger modeSnapshot & Record file setting Response mode4NAS Storage Status NAS server settingFile operation Syslog Status and Parameters Maintenance Export/Import file Q2 What kind of Ethernet cable is used by network camera? AppendixQ1 Status led does not light up 43/59 44/59 Q6 How can I restore the network camera to default value? Q10 The cover of network camera is warm. Is it normal? Q12 The process of upgrade firmware abortQ7 I cannot play the recorded video file A13 Camera from Internet ExplorerIp-discovery.comFree Ddns service 49/59 Current device Federal Communication Commission Interference Statement EU Countries Not Intended for Use EU Declaration of Conformity Weee Directive & Product Disposal 55/59 56/59 No Warranty 58/59 Network Camera User’s Manual 59/59