Edimax Technology PT-112E & MD-111E, PT-111E user manual Network Setting, LAN & PPPoE, Lan

Page 21

Network Camera User’s Manual

Network

Any changes made on this page will restart the system in order to validate the changes. Make sure every field is entered correctly before clicking on “finish”

Network Setting

“LAN” & “PPPoE”

The default type is LAN. Select PPPoE if using ADSL

1. LAN

The default status is Get IP address automatically. This could be tedious to perform software installation whenever the Network Camera starts. Therefore, once the network is set, especially for the IP address should be entered correctly. Select Use fixed IP address then the Network Camera will skip installation. The Network Camera will automatically restart and operate normally after a power outage. You can run IP installer to check the IP address assigned to the Network Camera if the IP address is forgotten,

21/59

Image 21

Contents PT-111E / PT-112E & MD-111E Table of Contents Minimum System Requirement OverviewPackage Contents Reset button Micro SD/SDHC Wired cover Slide coverConnections Internal Microphone Light sensor LensHardware Installation Power over Ethernet PoE  Using a PoE-enabled switch Locate the IP address of Network IP Camera Connect to the Network CameraNetwork Camera User’s Manual Initial Access to the Network Camera Video will be displayed Primary user’s capability Configuration functionsView capabilities Camera viewPan/Tilt & connection control buttons PT-111E / PT-112E only Client Setting 16/59 General Setting Host name Definitions in ConfigurationLED indicator System parametersAdjust by NTP server Time Setting Time zoneDaylight saving Current TimeSecurity setting SecurityManage user 20/59 Network Network SettingLAN & PPPoE LANDdns Setting Get IP address automatically Use fixed IP addressPPPoE 23/59 Access list setting Access listGeneral Setting Audio and Video settingVideo Setting Infrared Led SettingAudio Setting Schedule mode Video recordSchedule information 1NAS Record parametersVideo codec setting Audio codec settingStream Bit rateSnapshot and time display setting Camera control Camera control PT-111E / PT-112E onlyPatrol list setting Sun/Mon/Tue/Wed/Thu/Fri/Sat Select the days ApplicationMedia mode Trigger modeSnapshot & Record file setting Response mode4NAS Storage Status NAS server settingFile operation Syslog Status and Parameters Maintenance Export/Import file Appendix Q1 Status led does not light upQ2 What kind of Ethernet cable is used by network camera? 43/59 44/59 Q6 How can I restore the network camera to default value? Q12 The process of upgrade firmware abort Q7 I cannot play the recorded video fileQ10 The cover of network camera is warm. Is it normal? A13 Camera from Internet ExplorerIp-discovery.comFree Ddns service 49/59 Current device Federal Communication Commission Interference Statement EU Countries Not Intended for Use EU Declaration of Conformity Weee Directive & Product Disposal 55/59 56/59 No Warranty 58/59 Network Camera User’s Manual 59/59