JVC LYT2112-003A, WR-MG250 manuel dutilisation Parts and Functions, Preparation

Page 6

Parts and Functions

8

Strap

7 6

2 4

Front glass

4 1

35

Bottom view

1.Main casing grip

Attach the strap provided as shown in the diagram above.

2.Zoom lever

Zoom (tele/wide) while shooting.

3.Ring

Commercially available filters (67 mm diameter) can be attached.

4.Buckle (3 locations) Seal the marine case.

5.Grip attachment holes

You can attach the grip provided, or commercially available weights.

6.Still image lever

Press to take still images.

7.Video recording start/stop button Press once to start recording a video. Press again to stop.

8.Power button

Turns camera’s power on/off.

6

Preparation

AInspect the main casing for scratches and cracks.

Apply 2 or 3 drops of the anti-fog liquid provided onto a lens tissue paper (commercially available) or a clean cloth, and wipe the inner side of the marine case front glass.

BCheck the O-ring.

Using the pick provided, remove the O-ring from the main case.

B

Check the O-ring, O-ring contact surface, and groove in which the O-ring fits for foreign matter, nicks, cracks, etc.

Be sure to remove any foreign matter (dirt, sand, salt crystals, hair, lint, etc.).

¹For details, refer to the “O-ring Maintenance Manual”.

Caution

zNever use the O-ring in case of nicks and cracks.

zIf the O-ring is handled inappropriately, it can cause water leakage .

CApply grease to the O-ring and re-attach.

DClose the empty marine case (no camera inside).

ESubmerge the marine case in water and check that there are no water leaks.

(A Pg. 8)

Page 5 Page 7
Image 6
Page 5 Page 7
Contents WR-MG250 Safety Precaution Order to use this product safely Accessories Maintenance Kit Sold Separately Part Number MG100MTKITAnti-fog liquid Procedures for Using the Supplied Maintenance KitStrap Drying agentBuckle opener Silicone clothHexagonal wrench small Screw tightening keyParts and Functions PreparationAttaching the Marine Case to the Camera Recording the Video/Still Image Files Before recordingIf there is a need to detach immediately Perform maintenance on the marine case. a PgDetaching the camera If there is no need to detach immediatelyMaintenance on the marine case Wash the marine case in water while it is still sealedPerforming salt removal Applicable camera models SpecificationsStoring the O-ring Let it dry completely in a shaded areaWR-MG250 型環維護手冊 As a general rule, each time before using Remove the O-ringWipe off any residual grease JDirt JSand JHair JDust JSalt JLintJCracks JDistortion JCrushed JFrayed JNicks JSand corrosion Apply silicone grease on the O-ring Check for any foreign matter in the O-ring grooveInsert the O-ring after inspection ¹ Do not store in hot and humid locationsКольцом Moisture inside marine case Temperature and humidity during camera mountingTemperature difference during shooting Drastic change in water pressure
Top Page Image Contents