JVC WR-MG250, LYT2112-003A Detaching the camera, If there is a need to detach immediately

Page 9

BPress the video recording start/stop button or the still image lever to start recording.

Zooming (Tele)

Zooming

Still image lever (Wide) Shoot still images.

Video recording start/stop button

Start/stop the video recording.

CWhen you have finished recording, press and hold the power button for more than 2 seconds to turn off the camera.

z The camera’s power lamp goes out and the monitor turns off.

Detaching the camera

If there is a need to detach immediately:

ASubmerge the marine case in fresh water and shake the marine case in the upward, downward, left and right directions for at least 10 times, followed by rinsing it.

BRemove the marine case and wipe off water droplets on the case surface using a dry towel.

CFace the front glass of the marine case upwards, and open the buckles to remove the camera, while paying attention not to let water droplets at O-ring or buckles enter the case.

DUpon removing the camera, close the marine case again while paying attention not to allow water droplets enter the case, followed by tightening all the buckles.

¹Always perform maintenance on the marine case after using. (A Pg. 10)

If there is no need to detach immediately:

Perform maintenance on the marine case. (A Pg. 10)

9

Image 9
Contents WR-MG250 Order to use this product safely Safety PrecautionMaintenance Kit Sold Separately Part Number MG100MTKIT AccessoriesStrap Procedures for Using the Supplied Maintenance KitAnti-fog liquid Drying agentHexagonal wrench small Silicone clothBuckle opener Screw tightening keyPreparation Parts and FunctionsAttaching the Marine Case to the Camera Before recording Recording the Video/Still Image FilesDetaching the camera Perform maintenance on the marine case. a PgIf there is a need to detach immediately If there is no need to detach immediatelyMaintenance on the marine case Wash the marine case in water while it is still sealedPerforming salt removal Storing the O-ring SpecificationsApplicable camera models Let it dry completely in a shaded areaWR-MG250 型環維護手冊 Remove the O-ring As a general rule, each time before usingWipe off any residual grease JDirt JSand JHair JDust JSalt JLintJCracks JDistortion JCrushed JFrayed JNicks JSand corrosion Check for any foreign matter in the O-ring groove Apply silicone grease on the O-ring¹ Do not store in hot and humid locations Insert the O-ring after inspectionКольцом Temperature difference during shooting Temperature and humidity during camera mountingMoisture inside marine case Drastic change in water pressure