Attaching the Marine Case to the Camera
ASetup the camera.
z For models equipped with light, turn off the light.
z Open the lens cover.
z Set to the shooting mode (video/still image).
¹Even when the shooting mode is set to “video”, still images can be captured by pressing the still image lever during video recording.
zIt is recommended to set to the auto shooting mode.
zInsert the battery and micro SD card beforehand if needed.
zTo turn off the camera, press and hold the power button for more than 2 seconds.
BInsert the drying agent at the back of the base.
2 Catch
Drying agent 1 Pass underneath
CAttach the base to the bottom of the camera.
z Align the tripod screw hole at the bottom of
your camera with the screw of the base, and tighten the screw.
2 Tighten the screw
1 Open up the LCD monitor
Caution
zThe camera turns on automatically when the LCD monitor is opened. To turn off the camera, press and hold the power button for more than 2 seconds.
DFold the grip belt.
z Make sure the grip belt is not caught between the marine case when sealing.
1.Unlock the grip belt, pull the belt out and lock again.
Lock
2.Fold the grip belt and pass the front end through the inner side of the belt.
3.Pull the end that has been passed through the inner side of the belt and adjust the length. (If the end is pulled out too much, it may be recorded into the image or get caught in the
EOpen the marine case.
z If it is difficult to open buckles, use the small hexagonal wrench (buckle opener).
Small hexagonal wrench (Buckle opener)
FInsert the camera into the marine case. z Align the base attachment groove with the
base to insert.
Base attachment groove
Base
Marine case internal base
7