JVC WR-MG250, LYT2112-003A Wipe off any residual grease, JDirt JSand JHair JDust JSalt JLint

Page 15

Check for hair, dirt, sand, salt, dust, and other foreign matter

¹Even small foreign matter can cause water leakage.

Check for foreign matter that are not visible by rubbing gently with your fingers

¹Be sure to remove all foreign matter.

JDirt

 

JSand

 

JHair

 

 

 

 

 

 

 

 

 

 

JDust

JSalt

JLint

Wipe off any residual grease

Wipe off gently with a soft cloth or tissue paper.

¹After wiping, make sure the fiber of the cloth or tissue paper is not adhered to the O-ring.

Check for any deforms (distorted, crushed), cracks or cuts on the surface

Cracks on the O-ring can be easily spotted by bending and

Cracks

twisting it gently.

 

 

 

 

 

 

¹ Never use an O-ring if it is deformed, cracked, or

 

 

 

damaged in any way. It can cause water leakage.

 

 

 

¹Replace the O-ring with a brand new one every year.

Even if there are no nicks, cracks, etc., its effectiveness will deteriorate due to wear.

JCracks

 

JDistortion

 

JCrushed

 

 

 

 

 

 

 

 

 

 

JFrayed

JNicks

JSand corrosion

3

Image 15
Contents WR-MG250 Order to use this product safely Safety PrecautionMaintenance Kit Sold Separately Part Number MG100MTKIT AccessoriesDrying agent Procedures for Using the Supplied Maintenance KitStrap Anti-fog liquidScrew tightening key Silicone clothHexagonal wrench small Buckle openerPreparation Parts and FunctionsAttaching the Marine Case to the Camera Before recording Recording the Video/Still Image FilesIf there is no need to detach immediately Perform maintenance on the marine case. a PgDetaching the camera If there is a need to detach immediatelyMaintenance on the marine case Wash the marine case in water while it is still sealedPerforming salt removal Let it dry completely in a shaded area SpecificationsStoring the O-ring Applicable camera modelsWR-MG250 型環維護手冊 Remove the O-ring As a general rule, each time before usingWipe off any residual grease JDirt JSand JHair JDust JSalt JLintJCracks JDistortion JCrushed JFrayed JNicks JSand corrosion Check for any foreign matter in the O-ring groove Apply silicone grease on the O-ring¹ Do not store in hot and humid locations Insert the O-ring after inspectionКольцом Drastic change in water pressure Temperature and humidity during camera mountingTemperature difference during shooting Moisture inside marine case