AW
SCSI
REC
SEND AW/SEL MODE
MENU UP DOWN SET
PLAY
FREEZE
MONITOR 
LENS
REMOTE | DC IN |
ON 1 2 3 4 | POWER |
SEE INSTRUCTION MANUAL
AUTO W H I T E
O PERA T I O N
Auto white in operation
AUTO W H I TE
O K
Auto white operation completed
6. After pressing the MENU button twice to return to the normal screen, place a white object with the same light- ing conditions as the object to record, then zoom in to display white on the screen.
7. Press the AW (Auto White) button.
●When auto white is in operation, OPERATION will be displayed on the monitor screen.
●When the white balance is successfully set, OK will appear on the screen and the unit will return to the normal screen.
MEMO
When setting the VGA mode to FINE, using the SXGA mode or setting the unit to a slow shutter speed, the white balance operation may take some time before completion.
●Error display
When the auto white balance cannot be set, one of the following error messages will appear and the unit will return to the normal screen.
NG: OBJECT (bad object)
Displayed when the object consists of little whiteness or when the color temperature is not correct. Change to a white object and redo the white balance.
ERROR: LOW LIGHT (shortage of light)
Displayed when the lighting is too dark. Brighten the lighting and redo the white balance.
ERROR: OVER LIGHT (excessive light)
•Displayed when the lighting is too bright. Lower the brightness and redo the white balance.
•If the color temperature of the object changes when darkening the lighting, redo the white balance after pressing the AW button on the panel.