44 EN EDITING |
|
Dubbing To Or From A Video Unit | NOTES: |
Equipped With A DV Connector | ● It is recommended to use the AC Adapter as |
the power supply instead of the battery pack. | |
(Digital Dubbing) | ( pg. 14) |
● If a blank portion or disturbed image is played | |
It is also possible to copy recorded scenes from | back on the player during dubbing, the dubbing |
may stop so that an unusual image is not dubbed. | |
the camcorder onto another video unit equipped | ● Even though the DV cable is connected correctly, |
with a DV connector. Since a digital signal is | sometimes the image may not appear in step 4. If |
sent, there is little if any image or sound | this occurs, turn off the power and make |
deterioration. | connections again. |
| ● If “Playback Zoom” ( pg. 24) or “Playback |
| Special Effects” ( pg. 24) is attempted or |
| SNAPSHOT is pressed during playback, only the |
| original playback image recorded on the tape is |
| output from the DV IN/OUT connector. |
| ● When using a DV cable, be sure to use the |
| optional JVC |
To DV IN/OUT
Core filter 
DV cable (optional)
To DV IN/OUT
Video unit equipped with DV connector
To use this camcorder as a recorder
1
2 Connect this camcorder to a video unit equipped with a DV output connector using a DV cable as shown in the illustration.
3 Set the camcorder’s Power Switch to “PLAY”.
4
5 Press the Recording Start/Stop Button to engage the
●The “ DV IN ” indication appears on the screen.
6 Start playback on the player.
7 At the point you want to start dubbing, press the Recording Start/Stop Button to start
dubbing. The 
indication rotates.
8 Press the Recording Start/Stop Button again
to stop dubbing. The 
indication stops rotating.
9 Press 8 to return to the normal playback mode.
To use this camcorder as a player
1 Make sure all units are turned off.
2 Connect this camcorder to a video unit equipped with a DV input connector using a DV cable as shown in the illustration.
3 Start playback on the camcorder. ( pg. 20)
4 At the point you want to start dubbing, start recording on the video unit. (Refer to the video unit’s instruction manual.)
5 To stop dubbing, stop recording on the video unit, then stop playback on this camcorder.
NOTES:
●If no image is displayed on the LCD monitor, set “S/AV INPUT” to “OFF”. ( pg. 31, 36)
●Digital Dubbing is performed in the sound mode recorded on the original tape, regardless of the current “SOUND MODE” setting. ( pg. 32)