|
|
|
|
| GETTING STARTED | EN 13 | |
How To Attach The Core Filter |
|
|
|
|
| ||
|
|
|
| Power | |||
|
| ||||||
Attach the core filters to the cables. The core |
|
|
|
|
|
|
|
| This camcorder’s | ||||||
filter reduces interference. |
| ||||||
| lets you choose the most appropriate source of | ||||||
1 Release the stoppers on both ends of the |
| ||||||
| power. Do not use provided power supply units | ||||||
core filter. |
| with other equipment. | |||||
Stopper 
2 Run the cable through the core filter, leaving approx. 3 cm
Wind the cable once around the outside of the core filter as shown in the illustration.
Core filter
3 cm
Wind once.
3 Close the core filter until it clicks shut.
NOTES:
●Take care not to damage the cable.
●When connecting a cable, attach the end with the core filter to the camcorder.
Charging The Battery Pack
BATT. RELEASE
Open the cover.
Battery pack
To
DC connector
Arrow
Battery pack mount | mark |
Power switch
POWER/CHARGE lamp
AC Adapter
To AC outlet
1 Set the Power Switch to “OFF”.
2 With the arrow on the battery pack pointing right, push the battery pack slightly against the battery pack mount a.
3 Slide the battery pack to the right until it locks in place b.
4
5 Plug the AC Adapter into an AC outlet. The POWER/CHARGE lamp on the camcorder blinks to indicate charging has started.
6 When the POWER/CHARGE lamp goes out, charging is finished. Unplug the AC Adapter from the AC outlet. Disconnect the AC Adapter from the camcorder.
GETTING STARTED
CONTINUED ON NEXT PAGE