24 EN VIDEO PLAYBACK |
|
NOTES: | Beam Effective Area (indoor use) |
●It is recommended to use the AC Adapter as the power supply instead of the battery pack. ( pg. 15)
●To monitor the picture and sound from the camcorder without inserting a tape or memory
card*, set the camcorder’s Power Switch to “A” or “M”, then set your TV to the appropriate input
When using the remote control, be sure to point it at the remote sensor. The transmitted beam’s approximate effective distance for indoor use is
mode.
*
● Make sure you adjust the TV sound volume to its |
5 m (16 ft).
NOTE:
Remote sensor
minimum level to avoid a sudden burst of sound |
when the camcorder is turned on. |
The transmitted beam may not be effective or may cause incorrect operation when the remote sensor is directly exposed to sunlight or powerful lighting.
Playback Using The Remote Control
The
Installing The Battery
Buttons And Functions
The remote control uses one lithium battery (CR2025).
1 Pull out the battery holder by pushing the lock tab.
2 Insert the battery in the holder, and be sure to have the “+” mark visible.
2
1
13
Lock tab
A Infrared beam transmitting window
●Transmits the beam signal.
The following buttons are available only when the camcorder’s Power Switch is set to “PLAY”. B PAUSE Button
●Pauses the tape ( pg. 25)
Up Button ( pg. 26)
C
3 Slide the holder back in until you hear a click.
SLOW Rewind Button ( pg. 25) D REW Button
●Rewind/Reverse Shuttle Search on a tape ( pg. 22)
●Displays previous file in a memory card* ( pg. 29)
Left Button ( pg. 26)