14 EN GETTING STARTED
To detach the battery pack | Using The Battery Pack |
| |||||
Slide the battery pack to the left while pressing |
|
|
|
| |||
Perform steps 2 – 3 in “Charging The Battery | |||||||
BATT. RELEASE to detach it. | |||||||
Pack”. |
|
| |||||
|
|
|
|
| |||
Battery pack | Charging time |
| Maximum continuous recording time | ||||
|
|
| |||||
Approx. 1 hr. 30 min. |
| ||||||
|
|
|
|
| |||
Approx. 2 hr. 40 min. |
| Battery pack |
| LCD monitor on | Viewfinder on | ||
|
|
|
|
| |||
|
| 1 hr. 5 min. | 1 hr. 25 min. | ||||
|
|
|
| ||||
Approx. 5 hr. 40 min. |
| ||||||
|
|
|
|
| |||
|
| 2 hr. 20 min. | 3 hr. | ||||
|
|
|
| ||||
* Provided |
|
| |||||
|
|
|
|
|
| ||
|
|
| 5 hr. 25 min. | 7 hr. 5 min. | |||
NOTES: |
|
|
| ||||
|
|
|
|
|
| ||
|
| * Provided |
|
| |||
● This product includes patented and other |
|
| |||||
NOTES: |
|
| |||||
proprietary technology and will operate only |
|
| |||||
with JVC Data Battery. Use the JVC BN- | ● Recording time is reduced significantly under the | ||||||
VF707U/VF714U/VF733U battery packs. Using | following conditions: |
| |||||
generic | • Zoom or | ||||||
to the internal charging circuitry. | repeatedly. |
|
| ||||
● If the protective cap is attached to the battery | • The LCD monitor is used repeatedly. | ||||||
pack, remove it first. |
|
| • The playback mode is engaged repeatedly. | ||||
● During charging, the camcorder cannot be | • The LED Light is used. |
| |||||
operated. |
|
| ● Before extended use, it is recommended that you | ||||
● Charging is not possible if the wrong type of | prepare enough battery packs to cover 3 times the | ||||||
battery is used. |
|
| planned shooting time. |
| |||
● When charging the battery pack for the first time | ATTENTION: |
|
| ||||
or after a long storage period, the POWER/ |
|
| |||||
Before detaching the power source, make sure that | |||||||
CHARGE lamp may not light. In this case, remove | |||||||
the camcorder’s power is turned off. Failure to do so | |||||||
the battery pack from the camcorder, then try | |||||||
can result in a camcorder malfunction. | |||||||
charging again. |
|
| |||||
|
| Data Battery System |
| ||||
● If the battery operation time remains extremely |
| ||||||
short even after having been fully charged, the |
| ||||||
|
|
|
| ||||
You can check the remaining battery power and | |||||||
battery is worn out and needs to be replaced. | |||||||
Please purchase a new one. | the recordable time. |
| |||||
● Since the AC Adapter processes electricity | 1) Make sure the battery is attached and the | ||||||
internally, it becomes warm during use. Be sure to | Power Switch is set to “OFF”. |
| |||||
use it only in | 2) Open the LCD monitor fully. |
| |||||
● Using the optional | 3) Press BATT. DATA, and the battery status | ||||||
can charge the | |||||||
screen appears. |
| ||||||
battery pack without the camcorder. |
| ||||||
● It can be displayed on the viewfinder when the | |||||||
● After 5 minutes has elapsed in | |||||||
LCD monitor is closed. |
| ||||||
mode with the cassette inserted, the camcorder |
| ||||||
● It is displayed for approx. 3 seconds if the | |||||||
will automatically turn off its power supplied from | |||||||
button is pressed and released quickly, and for | |||||||
the AC adapter. In this case, the battery charge | |||||||
15 seconds if the button is pressed and hold | |||||||
starts if the battery is attached to the camcorder. |
for several seconds.
● If “COMMUNICATION ERROR” appears instead of the battery status even though you tried to press BATT. DATA several times, there may be a problem on the battery. In such a case, consult your nearest JVC dealer.