JVC GR-DF450 instruction manual Basic Recording, Tape Remaining Time, LCD Monitor And Viewfinder

Page 19

 

 

 

 

 

 

VIDEO RECORDING

EN 19

 

 

Basic Recording

 

 

 

NOTES:

 

 

 

 

 

 

 

 

If the Record-Standby mode continues for

NOTE:

5 minutes, the camcorder’s power shuts off

automatically. To turn the camcorder on again,

Before continuing, perform the procedures listed

push back and pull out the viewfinder again or

below:

close and re-openthe LCD monitor.

Power ( pg. 13)

When a blank portion is left between recorded

Loading A Cassette ( pg. 17)

scenes on the tape, the time code is interrupted

VIDEO/MEMORY*

and errors may occur when editing the tape. To

 

 

 

 

Power Zoom Lever

avoid this, refer to “Recording From The Middle Of

 

 

 

 

 

 

 

 

Power Switch

A Tape” ( pg. 21).

 

 

 

 

To turn the beep sounds off,  pg. 36, 38.

 

 

 

 

Recording Start/Stop Button

Tape Remaining Time

 

 

 

 

 

 

 

Lock Button

POWER/CHARGE Lamp

1 Remove the lens cap. ( pg. 11)

2 Open the LCD monitor fully.

3 Set the VIDEO/MEMORY Switch to “VIDEO”.*

4 Set the Power Switch to “A” or “M” while pressing down the Lock Button located on the switch.

The POWER/CHARGE lamp lights and the camcorder enters the Record-Standby mode. “PAUSE” is displayed.

To record in LP (Long Play) mode,  pg. 37.

5 To start recording, press the Recording Start/ Stop Button. “T REC” appears on the display while recording is in progress.

6 To stop recording, press the Recording Start/ Stop Button again. The camcorder re-enters the Record-Standby mode.

* GR-DF470/450 only

Approximate tape remaining time appears on the display.

“– h – – m” means the camcorder is calculating the remaining time. When the

remaining time reaches 2 minutes, the indication starts blinking.

The time required to calculate and display the remaining tape length, and the accuracy of the calculation, may vary according to the type of tape used.

LCD Monitor And Viewfinder

While using the LCD monitor:

Make sure the viewfinder is pushed back in. Pull on the end of the LCD monitor and open the LCD monitor fully. It can rotate 270° (90° downward, 180° upward).

While using the viewfinder:

Make sure the LCD monitor is closed and locked. Pull out the viewfinder fully.

180˚

VIDEO RECORDING & PLAYBACK

Approximate recording time

 

90˚

 

 

 

 

 

 

Tape

Recording mode

 

 

 

 

 

SP

LP

 

 

 

 

 

30 min.

30 min.

45 min.

 

 

 

 

 

60 min.

60 min.

90 min.

 

 

 

 

 

80 min.

80 min.

120 min.

 

 

 

 

 

CONTINUED ON NEXT PAGE

Image 19
Contents For Customer Use Dear CustomerModel No Serial No Mail Clip Recording Wipe/Fader EffectsNavigation Function Program AE with Special EffectsSafety Precautions Important Safety Instructions Contents EN Index Other Parts ConnectorsIndicators ControlsSound 12BI T 1555 During D.S.C. Recording Only GR-DF470/ 450 onlyDuring E-Mail Clip Recording GR-DF470/ 450 only 1h40m RECNOV 10 I T / M I10 00 AM 20 21 Only Before Using This CamcorderOperation Mode Indicator  pg  pg Brightness Control Indicator LCD monitorHow To Attach The Lens Cap Provided AccessoriesPlace here during shooting Audio extension cable provided Stereo microphone Slide the strap guide fully towards the eyeletBuckle Strap guide Open the cover To MIC EyeletClose the core filter until it clicks shut PowerHow To Attach The Core Filter Charging The Battery PackBATT. Release to detach it Data Battery SystemMaximum continuous recording time Using AC Power Operation ModeAbout Batteries Viewfinder Adjustment Grip AdjustmentDate/Time Settings Cassette holder cover Brightness Adjustment Of The DisplayTripod Mounting To protect valuable recordingsTo protect valuable files available only for SD Memory Card Close the card coverTape Remaining Time Basic RecordingLCD Monitor And Viewfinder Zoom ZoomingJournalistic Shooting Self RecordingDisplay Minutes Seconds Frames Frames = 1 second Time CodeBlank Search To control the speaker volumeNormal Playback Shuttle SearchTo choose whether or not the following If using a VCR , go to stepDisplays appear on the connected TV Installing The Battery Buttons And Functions Playback Using The Remote ControlFrame-By-Frame Playback Slow-Motion PlaybackPlayback Zoom Basic Shooting D.S.C. Snapshot Power Switch Lock ButtonApproximate Number of Storable Images Interval Shooting To cancel Interval Shooting modePress Snapshot Playback Zoom Normal Playback Of ImagesAuto Playback Of Images Playback Of Video ClipsDisappear Index Playback Of FilesViewing File Information Steps 1 3 in Playback Of Video Clips  pgTo make video clips from real-time camera image Mail Clip RecordingTo make video clips from recorded video footage Protecting Files Resetting The File NameTo delete the file Deleting FilesTo Remove Protection To remove protection from the currently displayed fileDPOF, and press SET Setting Print Information Dpof SettingSub Menu appears Initializing a Memory Card To Reset The Number Of PrintsFor Video and D.S.C.* Recording Menus Menus without Sub MenusMenus with Sub Menus WIPE/FADER  pg Program AE  pg Exposure  pg Balance  pg5SEC / 15SEC / 30SEC / 60SEC Recording MenusOFF Disengages the function ManualIndicator when optional microphone is Appear on screen when the camcorder isSeconds when the Power Switch is set from Factory-preset15SEC / 30SEC / 1MIN / 2MIN / 5MIN / 10MIN / 30MIN / 60MIN Sound Mode and NarrationPlayback Menus 640 x 480 / 1024 xPortuguês OFF / onSet 5S to 5S.  pg To take a snapshot in the 5-second recording modeLED Light Live Slow GR-DF470/450 onlySnapshot For Video Recording Motor Drive ModeSet r to OFF so that the Night-Alive indicator disappears Night-AliveTo return to automatic exposure control To reset to Auto FocusManual Focus Manual focus is recommended in situations listed belowSpot Exposure Control Iris LockBacklight Compensation To change the setting White Balance AdjustmentTo return to automatic white balance To deactivate the selected effect Wipe Or Fader EffectsRecording automatically OnlyTo make thumbnail images after video To cancel Navigation search midway Press 4/9, 3, 5 orPlayback To delete thumbnail imagesUnable to USE NAVIGATION, this Memory Card is not Compatible To use this camcorder as a recorder Dubbing To Or From a VCRTo use this camcorder as a player Digital Dubbing Equipped With a DV ConnectorUsing USB cable* B Using DV cable Using DV cableSet Narration to on or MIX.  pg Audio DubbingFor GR-DF470/450 owners To hear the dubbed sound during playbackPress START/STOP to begin editing Insert EditingVideo and D.S.C.* Playback PowerAdvanced features Video and D.S.C.* RecordingTroubleshooting EN Other problemsAppears when the tape ends during recording or playback Displays the battery remaining powerRemaining power level High Exhausted DUB Error Check CARD’S Write Protection Switch To clean the lens Cleaning The CamcorderTo clean the exterior To clean the LCD monitorAC Adapter Battery PacksCassettes LCD Monitor Memory Cards GR-DF470/450 onlySerious malfunctioning ProblemsDirty heads can cause the following About moisture condensationResponsible party Declaration of ConformityModel Number GR-DF470U GR-DF450U Trade NameØ3.5 mm, stereo CamcorderLCD Monitor and Viewfinder Dpof SettingTape Speed REC Mode Recording CapacityGR-DF470 GR-DF450 GR-DF430 Software Installation and PC Connection Guide Limited Liability How to handle a CD-ROM System Requirements For CyberLink DVD SolutionSoftware Installation Windows Page Updating Device Manager Windows 98SE only Installing USB Mass Storage Class driverTo USB connector Connecting the USB cableTo USB connector To DV connector ConnectorData SettingStill ClipsCopying Files to the PC Windows Still images When using Windows 98SEClick OK When using Windows 2000/Me/XPConnections Macintosh Viewing the Contents of a Memory Card MacintoshNavigation data Still images Dpof Setting dataVideo Clips Playing Back Files on the PC Macintosh Transfer the still images Overview of Enjoying the Moving or Still Images on the PCMemory Card Via the USB cable