GETTING STARTED EN 17
Grip Adjustment
1 Adjust the velcro strip.
2 Pass your right hand through the loop and grasp the grip.
3 Adjust your thumb and fingers through the grip to easily operate the Recording Start/Stop Button, Power Switch and Power Zoom Lever. Be sure to fasten the
velcro strip to your preference.
Viewfinder Adjustment
1 Set the Power Switch to “REC” while pressing down the Lock Button located on the switch.
2 Make sure the LCD monitor is closed and locked. Pull out the viewfinder fully and adjust it manually for best viewability.
3 Turn the Dioptre Adjustment Control until the indications in the viewfinder are clearly focused.
Example:
Dioptre Adjustment Control
CAUTION:
When retracting the viewfinder, take care not to pinch your fingers.
Brightness Adjustment Of The Display
1 Set the Power Switch to “REC” or “PLAY” while pressing down the Lock Button located on the switch.
If you are in Recording mode, set the recording mode to “M”. ( pg. 16)
2 Open the LCD monitor |
|
fully. ( pg. 20) | MENU |
●To adjust the brightness of
the viewfinder, pull out the
viewfinder fully and setBRIGHT “PRIORITY” to “FINDER”
( pg. 32, 34).
3 Press MENU. The Menu Screen appears. If you are in Playback mode, please proceed to step 5.
4 Press 
, 
, 
or 
to select “DISPLAY”, and press SET. The DISPLAY Menu appears.
5 Press 
, 
, 
or 
to select “BRIGHT”, and press SET. The Menu Screen closes and the brightness control MENU appears.
6 Press 
or 
until the appropriate brightness is reached and press SET or 
.
7 Press MENU. The Menu screen closes.
Tripod Mounting
To attach the camcorder to a tripod, align the direction stud and screw to the mounting socket and stud hole on the camcorder. Then tighten the screw clockwise.
● Some tripods are not equipped with studs.
GETTING STARTED