JVC GR-DX35 manual Select Scenes, To S/AV #, Editing Extension cable provided, To Pause in a

●Make sure to set “S/AV INPUT” to “OFF” in the Menu Screen (
pg. 24).

●When editing on a VCR equipped with a DV input connector, an optional DV cable can be connected instead of an S-Video cable and audio/video cable.

5 If using a Fade/Wipe at the beginning of the scene, press FADE/WIPE Y on the remote control.

•Cycle through the effects by pressing repeatedly, and stop when the one you want is displayed.

6 At the beginning of the scene, press EDIT IN/OUT

Oon the remote control. The Edit-In position appears in the Random Assemble Editing Menu.

7 At the end of the scene, press EDIT IN/OUT O. The Edit-Out position appears in the Random Assemble Editing Menu.

8 If using a Fade/Wipe at the end of the scene, press

FADE/WIPE Y.

To S/AV #

S-Video/Audio/Video/ Editing cable (provided)

Editing Extension cable (provided)

To Remote PAUSE or R.A.EDIT

To PAUSE IN a
	Q
Y	j
I	A
O
	P

Connector cover**

To AUDIO, VIDEO* and S-Video connectors

VCR

TV

•Cycle through the effects by pressing repeatedly, and stop when the one you want is displayed.

•If you select a Fade/Wipe effect for an Edit-Out point, the effect is automatically applied to the following Edit-In point.

•When you use Fade/Wipe effects, that time is included in the total time.

9 If using Playback Special Effects, press EFFECT I (
pg. 28).

10 Repeat steps 6 through 9 to register additional scenes.

•To change previously registered points, press CANCEL P on the remote control. The registered points disappear, one at a time, from the most recently registered point.

•If you are not using Fade/Wipe or Programme AE with special effects, repeat steps 6 and 7 only.

NOTES:

● When choosing a scene, set Edit-In and Edit-Out points

so that there is a relatively large difference between

them.

● If the search time for an in-point exceeds 5 minutes, the

recording deck’s Record-Standby mode will be cancelled

and editing will not take place.

● If there are blank portions before or after the Edit-In and

Edit-Out points, a blue screen may be included in the

edited version.

● Since time codes register time only as accurately as

*Connect when the S-Video connection is not used.

**When connecting cables, open this cover.

SELECT SCENES

4 Point the remote control at the camcorder’s remote sensor. Press PLAY (4) j and then press R.A.EDIT ON/OFF A on the remote control.

The Random Assemble Editing Menu appears.

seconds, the time code total time may not match the total

programme time exactly.

● Turning off the camcorder’s power erases all registered

Edit-In and Edit-Out points.

● If you select Sepia or Monotone mode from Programme

AE with special effects, you cannot use the Black & White

Fader. In this case the Black & White indicator begins

blinking. Once the next Edit-In point is registered, the

effect is turned off. To combine these effects, use Sepia

or Monotone during recording, then use the Black &

White Fader during Random Assemble Editing.

● It is not possible to use Fade/Wipe effects and

Programme AE with special effects during Random

Assemble Editing using a DV cable.

Continued on next page.

EN

USING THE REMOTE CONTROL UNIT 31