JVC GR-DVP3 specifications 68 EN, Insert Editing

Press REW (2) until the Edit-In point is located, then press PAUSE (6).

68 EN USING THE REMOTE CONTROL UNIT (cont.)

Display

6w

12 : 34

Remote sensor

START/STOP

INSERT

REW PLAY

Insert Editing

You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in and outpoints. The original audio remains unchanged.

NOTES:

●Before performing the following steps, make sure that “TIME CODE” is set to “ON” in the Menu Screen (
pg. 43, 45).

●Insert Editing is not possible on a tape recorded in the LP mode or on a blank portion of a tape.

●To perform Insert Editing while watching in the television, make connections (
pg. 24).

1 Play back the tape, locate the Edit-Out point and press PAUSE (6). Confirm the time code at this point (
pg. 43, 45).

2

3 Press and hold INSERT (w) on the remote control, then press PAUSE (6). “6w” and the Time Code (min.:sec.) appear and the camcorder enters Insert- Pause mode.

4 Press START/STOP to begin editing.

•Confirm the insert at the time code you checked in step 1.

•To pause editing, press START/STOP. Press it again to resume editing.

5 To end Insert Editing, press START/STOP, then STOP (5).

NOTES:

● Program AE with special effects (
pg. 48, 49) can be

used to spice up the scenes being edited during Insert

Editing.

STOP

PAUSE

● During Insert Editing, the date and time information

changes.

● If you perform Insert Editing onto a blank space on the

tape, the audio and video may be disrupted. Make

sure you only edit recorded areas.

● During Insert Editing, when the tape moves to scenes

recorded in the LP mode or a blank portion, Insert

Edting stops (
pg. 91).