JVC LYT1154-001C, GR-HD1 manual Other problems, Is discharged, Camcorder When the LCD monitor’s

					EN 73
Other problems
	SYMPTOM		POSSIBLE CAUSES		CORRECTIVE ACTION
26.	The CHARGE indicator on the	26.	•The temperature of the	26.	•To protect the battery, it is
	AC Power Adapter/Charger		battery is extremely high/low.		recommended to charge it in
	does not light.		•Charging is difficult in places		places with a temperature of
			subject to extremely high/		10°C to 35°C (50°F to 95°F).
			low temperatures.		(☞ pg. 78)
27.	“SET DATE/TIME!” appears.	27.	•The built-in clock’s	27.	•Connect the camcorder to an
			rechargeable lithium battery		AC outlet using the AC Power
			is discharged.		Adapter/Charger for over 24
			•The previously set date/time		hours to charge the clock’s
			is erased.		lithium battery. (☞ pg. 17)
28.	There is no picture.	28.	•The camcorder is not getting	28.	•Turn the camcorder’s power
			power, or some other		off and on again. (☞ pg. 16)
			malfunction exists.
29.	Some functions are not	29.	•The Power Switch is set to	29.	•Set the Power Switch to “M”.
	available using the MENU		“A”.		(☞ pg. 16)
	Wheel.
30.	Files stored in the memory	30.	•Files stored in the memory	30.	•Remove protection from the
	card cannot be deleted.		card are protected.		files stored in the memory
					card and delete them.
					(☞ pg. 31 – 32)
31.	When the image is printed	31.	•This is not a malfunction.	31.	•By recording with “OIS”
	from the printer, a black bar				activated (☞ pg. 35, 37) this
	appears at the bottom of the				can be avoided.
	screen.
32.	When the camcorder is	32.	•The i.LINK cable was	32.	•Turn the camcorder’s power
	connected via the i.LINK		plugged/unplugged with		off and on again, then
	connector, the camcorder does		power turned on.		operate it.
	not operate.
33.	The rear of the LCD monitor is	33.	•The light used to illuminate	33.	•Close the LCD monitor to
	hot.		the LCD monitor causes it to		turn it off or set the Power
			become hot.		Switch to “OFF”, and let the
					unit cool down.	REFERENCES
34.	Images on the LCD monitor	34.	•In places subject to low	34.	•Adjust the brightness and
	appear dark or whitish.		temperature, images become		angle of the LCD monitor.
			dark due to the		(☞ pg. 14, 15)
			characteristics of the LCD
			monitor. When this happens,
			the displayed colors differ
			from those that are actually
			recorded. This is not a defect
			of the camcorder.
			•When the LCD monitor’s
			fluorescent light reaches the
			end of its service life, images
			on the LCD monitor become
			dark. Consult your nearest
			JVC dealer.

CONTINUED ON NEXT PAGE