JVC LYT0216-001B Scene 5-second recording, Engage 5S Mode, START/STOP button Display

26ENRECORDING

AdvancedFeatures(Cont.)

Scene (5-second recording)

Record a vacation or an important event in 5-second clips to keep the action moving. The 5-Second function may also be activated during Full Auto operation. But the White Balance remains in the previously adjusted condition. While the 5-Second mode is activated, Fade/Wipe (☞ pg. 36), P.AE/Effects (☞ pg. 42) and other manual operations cannot be performed.

Power Dial

	A		OFF	A
	L	Y
P				M
				5S

Lock button

Dissolves during 5 second mode recording

Before performing the following procedure, make sure that the Digital Image Stabilizer (DIS) is set to “OFF” (☞ pg. 31).

Select “5SD” at the System Menu (☞ pg. 34). “5SD MODE” appears in step 2 below. Record one

5-second clip, and the image at the end of the clip is stored. If you record the next clip within 5 minutes, the previous scene dissolves as the new scene appears.

•If you turn the power off, the stored image will be lost.

START/STOP button

Display

MANUAL

REC PAUSE 444

5S MODE

After 5 sec.

MANUAL

REC

PAUSE

5S MODE

Record-Standby

1 SELECT OPERATION MODE

Turn the Power Dial to “5S” while pressing down the lock button located on the dial.

2 PULL OUT VIEWFINDER OR OPEN LCD MONITOR

Pull out the viewfinder fully. “5S MODE” appears.

3 ENGAGE 5S MODE

Then press START/STOP. The tally lamp lights and beep sounds to indicate the start of recording, and after 5 seconds the camcorder enters Record-Standby mode.

•If you press and hold START/STOP within 5 seconds after recording starts, Record- Standby mode is not engaged.

4 END 5-SECOND MODE RECORDING Set the Power Dial to the “ A ”, “ M ” or “OFF” position.

To Take A Snapshot In The 5-Second Mode . . .

.... turn the Progressive Dial to any Snapshot mode

and instead of pressing START/STOP in step 3, press the Progressive Button. The camcorder records a 5-second still with the shutter sound (☞ pg. 28). But when the Scene is set to animation (☞ pg. 35) this function is not available.

NOTE:

When “SCENE” is set to “ANIM.” in the System Menu, the 5-second recording funcion is not available. Animation recording of a 1/8-second clip is taken instead (☞ pg. 35).