JVC LYT0216-001B 70 EN, Tape END appears, Don’t work, Connect the AC Power Adapter/Charger

70EN

TROUBLESHOOTING

If, after following the steps in the chart below, the problem still exists, please consult your nearest JVC dealer.

SYMPTOM POSSIBLE CAUSES

1.No power is supplied. 1. •The power is not connected properly.

•The battery is dead. •The LCD monitor is not

open fully or the viewfinder is not pulled out when recording.

2.“SET DATE/TIME!” 2. •The built-in rechargeable

appears.	clock lithum battery is
	discharged and the
	previously set date/time is
	erased.
3. Recording cannot be	3. •The tape’s record safety tab
performed.	is set to “SAVE”.
	•The Power Dial is set to
	“PLAY”.
	•“TAPE END” appears.
	•The cassette's cover is open.
4. There is no playback	4. •The camcorder is not getting
picture.	power, or some other
	malfunction exists.
5. Some functions are not	5. •The Power Dial is set to
available using the MENU	“	A	”.
button.
6. Some functions are not	6. •The Power Dial is set to
available using the Select	“	A	”, “5S” and “ ”.

Dial.

7.The focus does not adjust 7. •Focus is set to “MANUAL”.

automatically.•The recording was done in a dark place, or the contrast was low.

•The lens is dirty or covered with condensation.

8.The cassette won’t load 8. •The cassette is in the wrong

properly.	position.
	•The battery’s charge is low.
9. Play, Rewind and	9. •The Power Dial is not set to
Fast-Forward functions	“PLAY”.
don’t work.

CORRECTIVE ACTION

1.•Connect the AC Power Adapter/Charger

securely (☞ pg. 10). •Replace the dead battery with a fully charged one

(☞ pg. 9).

•Open the LCD monitor fully or pull out the viewfinder. The LCD monitor turns on/off when it is opened/closed at approx. 90° while the Power Dial is set to any position except “OFF” if the viewfinder is not fully pulled out.

2.•Connect the camcorder to an AC outlet using the AC Power Adapter/Charger etc. for over 24 hours to charge the clock lithum battery (☞ pg. 11).

3.•Set the tape’s record safety tab to “REC” (☞ pg. 12).

•Set the Power Dial to “ A ”,

“M ”, “5S” or “” (☞ pg. 17).

•Replace with new cassette (☞ pg. 12).

•Close the cassette's cover.

4.•Turn the camcorder’s power off and on again (☞ pg. 19).

5.•Set the Power Dial to any position except “ A ” (☞ pg. 17).

6.•Set the Power Dial to any position except “ A ”, “5S” and “” (☞ pg. 17).

7.•Set Focus to “AUTO”

(☞ pg. 45).

•Clean the lens and check the focus again (☞ pg. 75).

8.•Set it in the right position

(☞ pg. 12).

•Install a fully charged battery (☞ pg. 8).

9.•Set the Power Dial to “PLAY” (☞ pg. 50).