JVC LYT0216-001B specifications Self-Timer, Engage SELF-TIMER Mode, Stop SELF-TIMER Recording

EN27

Self-Timer

Once the camcorder is set, the camcorder operator can become part of the scene in a more natural way adding the final touch to a memorable picture.

When the START/ STOP button is pressed, the tally lamp changes as shown at right:

Begins blinking	´ Blinks quickly	´ Stops blinking and
(Self-Timer starts)	(Self-Timer shooting		stays on
	starts soon)		(Self-Timer shooting
		4	starts)
	After approx. 15 sec.

Power Dial

A

OFF

A	Y
L
P

M

5S

Lock button

Display

START/STOP button

MANUAL

– – –

PAUSE

After 15 sec.

MANUAL

REC

444

Self-Timer indication

During recording

1 SELECT OPERATION MODE

Turn the Power Dial to “ ” while pressing down the lock button located on the dial.

2 PULL OUT VIEWFINDER OR OPEN LCD MONITOR

Pull out the viewfinder fully.

•The camcorder enters the Record-Standby mode.

•You can tilt the LCD monitor upward to 180 degrees so that it faces forward and view yourself while self-recording (with the viewfinder pushed back).

3 ENGAGE SELF-TIMER MODE

Press START/STOP.

After 15 seconds, the beep sounds and recording begins.

4 STOP SELF-TIMER RECORDING

Press START/STOP.

•The camcorder re-enters Record-Standby mode.

5 END SELF-TIMER RECORDING

Set the Power Dial to the “ A ”, “ M ” or “OFF” position.

•When turning to “OFF”, it is not necessary to press down the lock button.

To Take A Snapshot In The Self-Timer Mode . . .

.... in step 3, turn the Progressive Dial to any

Snapshot mode, then press the Progressive Button (☞ pg. 28). After approx. 15 seconds, a snapshot will be taken.

NOTE:

When the Progressive Dial is set to “VIDEO”, the Self-Timer records using the Progressive Mode.