JVC 0206ASR-NF-VM, LYT1528-001B Power, How To Attach The Core Filter, Charging The Battery Pack

Connect the AC Adapter to the camcorder.

GETTING STARTED EN 13

How To Attach The Core Filter

Attach the core filters to the cables. The core filter reduces interference.

1 Release the stoppers on both ends of the core filter.

Power

This camcorder’s 2-way power supply system lets you choose the most appropriate source of power. Do not use provided power supply units with other equipment.

Stopper

2 Run the cable through the core filter, leaving approx. 3 cm (1-3/16") of cable between the cable plug and the core filter.

Wind the cable once around the outside of the core filter as shown in the illustration.

Core filter

3 cm (1-3/16")

Wind once

3 Close the core filter until it clicks shut.

NOTES:

●Take care not to damage the cable.

●When connecting a cable, attach the end with the core filter to the camcorder.

Charging The Battery Pack

	Battery pack mount
	PUSH
Battery	BATT.
pack	1
Arrow	2
	POWER/

CHARGE lamp

To DC connector

Power switch

AC Adapter

To AC outlet

GETTING STARTED

1 Set the Power Switch to “OFF”.

2 With the arrow on the battery pack pointing downward, push the battery pack slightly against the battery pack mount 1.

3 Slide down the battery pack until it locks in place 2.

4

5 Plug the AC Adapter into an AC outlet. The POWER/CHARGE lamp on the camcorder blinks to indicate charging has started.

6 When the POWER/CHARGE lamp goes out, charging is finished. Unplug the AC Adapter from the AC outlet. Disconnect the AC Adapter from the camcorder.

CONTINUED ON NEXT PAGE