GETTING STARTED EN 17
Grip Adjustment
1 Adjust the velcro strip.
Brightness Adjustment Of The Display
●Before making the
adjustment, remove any security tags that may be attached to the velcro.
2 Pass your right hand through the loop and grasp the grip.
1 Set the Power Switch to “REC” or “PLAY” while pressing down the Lock Button located on the switch.
2 Open the LCD monitor fully. ( pg. 19)
3
2
1 |
4 |
3 Adjust your thumb and fingers through the grip to
easily operate the Recording Start/Stop Button, Power Switch and Power Zoom Lever. Be sure to fasten the velcro strip to your preference.
Viewfinder Adjustment
●To adjust the brightness of the viewfinder, pull out the
viewfinder fully and set “PRIORITY” to “FINDER” MENU ( pg. 31, 33).
3 Press MENU. The Menu Screen appears. If you are in Playback mode, please proceed to Step 5.
BRIGHT
– 5
BRIGHT
–5
GETTING STARTED
1 Set the Power Switch to “REC” while pressing down the Lock Button located on the switch.
2 Make sure the LCD monitor is closed and locked. Pull out the viewfinder fully and adjust it manually for best viewability.
3 Turn the Diopter Adjustment Control until the indications in the viewfinder are clearly focused.
Example:
Diopter Adjustment Control
CAUTION:
When retracting the viewfinder, take care not to pinch your fingers.
4 Press 3, 4, 2 or 1 to select “DISPLAY”, and press SET. The DISPLAY Menu appears.
5 Press 3, 4, 2 or 1 to select “BRIGHT”, and press SET. The Menu Screen closes and the brightness control menu appears.
6 Press 3 or 4 until the appropriate brightness is reached and press SET or 2.
7 Press MENU. The menu screen closes.
Tripod Mounting
To attach the camcorder to a tripod, align the direction stud and screw to the mounting socket and stud hole on the camcorder. Then tighten the screw clockwise.
● Some tripods are not equipped with studs.