JVC 0206ASR-NF-VM, LYT1528-001B manual Digital Dubbing, Dubbing To Or From a Video Unit

Set the camcorder’s Power Switch to “PLAY”. Set “REC MODE” to “SP” or “LP”. ( pg. 35) Start playback on the player.

	EDITING EN 43
Dubbing To Or From A Video Unit	NOTES:
Equipped With A DV Connector	● It is recommended to use the AC Adapter as
	the power supply instead of the battery pack.
(Digital Dubbing)	( pg. 15)
	● If a blank portion or disturbed image is played
It is also possible to copy recorded scenes from	back on the player during dubbing, the dubbing
	may stop so that an unusual image is not dubbed.
the camcorder onto another video unit equipped
	● Even though the DV cable is connected correctly,
with a DV connector. Since a digital signal is
	sometimes the image may not appear in step 4. If
sent, there is little, if any, image or sound	this occurs, turn off the power and make
deterioration.	connections again.
	● If “Playback Zoom” ( pg. 25) or “Playback
	Special Effects” ( pg. 25) is attempted or
	SNAPSHOT is pressed during playback, only the
	original playback image recorded on the tape is
	output from the DV IN/OUT connector.
	● When using a DV cable, be sure to use the
	optional JVC VC-VDV204U or VC-VDV206U DV
	cable.

To DV IN/OUT

Core filter DV cable (optional)

To DV IN/OUT

Video unit equipped with DV connector

To use this camcorder as a recorder

1 Make sure all units are turned off.

2 Connect this camcorder to a video unit equipped with a DV output connector using a DV cable as shown in the illustration.

3

4

5

6 Press the Recording Start/Stop Button to engage the Record-Pause mode.

•The “ DV IN ” indication appears on the screen.

7 At the point you want to start dubbing, press the Recording Start/Stop Button to start

dubbing. The indication rotates.

8 Press the Recording Start/Stop Button again

to stop dubbing. The indication stops rotating.

ADVANCED FEATURES

To use this camcorder as a player

1 Make sure all units are turned off.

2 Connect this camcorder to a video unit equipped with a DV input connector using a DV cable as shown in the illustration.

3 Start playback on the camcorder. ( pg. 21)

4 At the point you want to start dubbing, start recording on the video unit. (Refer to the video unit’s instruction manual.)

5 To stop dubbing, stop recording on the video unit, then stop playback on this camcorder.

9 Press 7 to return to the normal playback mode.

NOTE:

Digital Dubbing is performed in the sound mode recorded on the original tape, regardless of the current “SOUND MODE” setting. ( pg. 32)