Time Code
During recording, a time code is recorded on the tape. This code is to confirm the location of the recorded scene on the tape during playback.
If recording starts from a blank portion, the time code begins counting from “00:00:00” (minute:second:frame). If recording starts from the end of a previously recorded scene, the time code continues from the last time code number.
To perform Random Assemble Editing ( pg. 37 – 39), time code is necessary. If during recording a blank portion is left partway through the tape, the time code is interrupted. When recording is resumed, the time code starts counting up again from “00:00:00”. This means the camcorder may record the same time codes as those existing in a previously recorded scene. To prevent this, perform “RECORDING FROM THE MIDDLE OF A TAPE” in the following cases;
•When shooting again after playing back a recorded tape.
•When power shuts off during shooting.
•When a tape is removed and
•When shooting using a partially recorded tape.
•When shooting on a blank portion located partway through the tape.
•When shooting again after shooting a scene then opening/closing the cassette holder cover.
|
|
|
| Display |
|
| ||
|
|
|
|
|
|
|
| Minutes |
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
| Seconds |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| Frames |
|
|
|
|
|
|
|
| |
1 |
| 2 : 3 |
| 4 : 2 |
| 4 |
| (25 frames = 1 second) |
|
|
|
| |||||
Frames are not displayed |
|
| ||||||
during recording. |
|
| ||||||
RECORDING FROM THE MIDDLE OF A TAPE
1 Play back a tape or use Blank Search ( pg. 15) to find the spot at which you want to start recording, then engage the Still Playback mode ( pg. 14, “Normal Playback”).
2 Set the Power Switch u to “ 
” or “ 
” while pressing down the Lock Button y located on the switch, then start recording.
NOTES:
●The time code cannot be reset.
●During
●The time code is displayed only when “TIME CODE” is set to “ON” ( pg. 31).
EN
Normal Playback
1 Load a tape ( pg. 9).
2 Set the VIDEO/MEMORY Switch 4 to “VIDEO”, then set the Power Switch u to “PLAY” while pressing down the Lock Button y located on the switch. To start playback, press 4/67.
•To stop playback temporarily (Still Playback), press 4/67.
•To stop playback, press 55.
•Press 26 to rewind, or 38 to
•
•Press the Zoom Button T A on the remote control to zoom in (up to 44X), or W S to zoom out. You can also magnify a particular part of an image ( pg. 35).
•At any time, pressing 4/67 resumes normal playback.
Available only with the remote control ( pg. 35)
To Control The Speaker Volume:
Rotate the MENU/VOLUME wheel % so that the volume level indicator T on the display moves to obtain the appropriate volume.
ATTENTION
During Shuttle Search, parts of the picture may not be clearly visible, particularly on the left side of the screen.
14 | TAPE RECORDING |
| TAPE PLAYBACK |