HOW TO ATTACH THE CORE FILTER
Attach the Core Filter(s) (if provided with your model ☞ pg. 5) to an optional cable(s). The Core Filter reduces interference.
1
Stopper
Release the stoppers on both ends of the Core Filter.
23 cm
Wind once
Run the cable through the Core Filter, leaving approx. 3 cm of cable between the cable plug and the Core Filter. Wind the cable once around the outside of the Core Filter as shown in the illustration.
• Wind the cable so that it is not slack.
NOTE:
Take care not to damage the cable.
3
Close the Core Filter until it clicks shut.
■When connecting cables, attach the end with the Core Filter to the camcorder.
■Be sure to use a cable with a thickness that will allow it to be wound around the core filter.
AUTOMATIC DEMONSTRATION
Automatic Demonstration takes place when | % |
“DEMO MODE” is set to “ON” |
■Automatic Demonstration starts when there is no operation for about 3 minutes after the Power Switch u is set to “ 
” or “ 
” and no cassette is in the camcorder.
■Performing any operation during the demonstration stops the demonstration temporarily. If no operation is performed for more than 3 minutes after that, the demonstration will resume.
■ “DEMO MODE” remains “ON” even if the camcorder power is | y |
turned off. |
|
■To cancel Automatic Demonstration:
1.Set the Power Switch u to “ 
” while pressing down the Lock Button y located on the switch and press the MENU/VOLUME wheel % in. The Menu Screen appears.
2.Rotate the MENU/VOLUME wheel % to select “ 
(SYSTEM)” and press it.
3. Rotate the MENU/VOLUME wheel % to select “DEMO MODE” and press it. The Sub Menu appears.
4. Rotate the MENU/VOLUME wheel % to select “OFF” and press it.
5. Rotate the MENU/VOLUME wheel % to select “ 
RETURN”, and press it twice. The normal screen appears.
NOTE:
u
Sub Menu
SYSTEM
DEMO MODE – OF F
ON
RETURN
If you do not detach the Lens Cap, you cannot see the actual changes of the Automatic Demonstration activated on the LCD monitor or viewfinder.
EN
6