JVC LYT1145-001A manual LCD Monitor, Main Unit, How to handle a CD-ROM

Page 45

LCD Monitor

1.To prevent damage to the LCD monitor, DO NOT . . .

... push it strongly or apply any shocks.

... place the camcorder with the LCD monitor on the bottom.

2.To prolong service life . . .

... avoid rubbing it with coarse cloth.

3.Be aware of the following phenomena for LCD monitor use.

These are not malfunctions:

While using the camcorder, the surface around the LCD monitor and/or the back of the LCD monitor may heat up.

If you leave power on for a long time, the surface around the LCD monitor becomes hot.

Main Unit

1.For safety, DO NOT . . .

... open the camcorder’s chassis.

... disassemble or modify the unit.

... short-circuit the terminals of the battery pack. Keep it away from metallic objects when not in use.

... allow inflammables, water or metallic objects to enter the unit.

... remove the battery pack or disconnect the power supply while the power is on.

... leave the battery pack attached when the camcorder is not in use.

2.Avoid using the unit . . .

... in places subject to excessive humidity or dust.

... in places subject to soot or steam such as near a cooking stove.

... in places subject to excessive shock or vibration.

... near a television set.

... near appliances generating strong magnetic or electric fields (speakers, broadcasting antennas, etc.).

... in places subject to extremely high (over 40°C) or extremely low (under 0°C) temperatures.

3.DO NOT leave the unit . . .

... in places of over 50°C.

... in places where humidity is extremely low (below 35%) or extremely high (above 80%).

... in direct sunlight.

... in a closed car in summer.

... near a heater.

4.To protect the unit, DO NOT . . .

... allow it to become wet.

... drop the unit or strike it against hard objects.

... subject it to shock or excessive vibration during transportation.

... keep the lens directed at extremely bright objects for long periods.

... expose the lens to direct sunlight.

... carry it by holding the LCD monitor or the viewfinder.

... swing it excessively when using the shoulder strap or the grip.

5.Dirty heads can cause the following problems:

No picture during playback.

Blocks of noise appear during playback.

During recording or playback, the Head Clog Warning indicator “” appears.

Recording cannot be performed properly.

In such cases, use an optional cleaning cassette. Insert it and play back. If the cassette is used more than once consecutively, damage to the video heads may result. After the camcorder plays back for about 20 seconds, it stops automatically. Also refer to the cleaning cassette’s instructions.

If, after using the cleaning cassette, the problems still exist, consult your nearest JVC dealer. Mechanical moving parts used to move the video heads and video tape tend to become dirty and worn out over time. In order to maintain a clear picture at all times, periodic check-ups are recommended after using the unit for about 1,000 hours. For periodic check-ups please consult your nearest JVC dealer.

How to handle a CD-ROM

Take care not to soil or scratch the mirror surface (opposite to the printed surface). Do not write anything or put a sticker on either the front or back surface. If the CD-ROM gets dirty, gently wipe it with a soft cloth outward from the centre hole using a circular motion.

Do not use conventional disc cleaners or cleaning spray.

Do not bend the CD-ROM or touch its mirror surface.

Do not store your CD-ROM in a dusty, hot or humid environment. Keep it away from direct sunlight.

EN

CAUTIONS 45

Image 45
Contents GR-D70 GR-D60 Contents Blue to N Neutral or Black Brown to L Live or Red Dear CustomerBefore recording an important scene Some DO’S and DON’TS on the Safe USE of EquipmentAC Adapter AP-V11E or AP-V13E Make sure the arrow is Pointing upwardLens Cap See below for attachment SlotStopper Wind onceSub Menu Charging the Battery Pack PowerUsing the Battery Pack Using AC PowerViewfinder Adjustment Grip AdjustmentLithium-ion is vulnerable in colder temperatures About BatteriesShoulder Strap Attachment Approximate recording time Tape Recording modeTripod Mounting Loading/Unloading a CassetteDate/Time Settings Recording Mode SettingScreen closes To Unload a Memory Card Loading a Memory Card Picture Quality/Image Size SettingLabel Clipped edge Memory card DisplayShooting while using the LCD monitor Open To Adjust The Brightness Of The DisplayBasic Recording LCD monitor fullyPower-Linked Operation Operation ModeJournalistic Shooting Self-RecordingTime Code To Control The Speaker VolumeRecording from the Middle of a Tape Normal PlaybackBlank Search To cancel Blank Search midwayPress Blank Search PressTo AV Connector cover If using a VCR . . . go to step If not . . . go to stepCvbs video out select switch To TV or VCR ConnectionsTo Delete Unwanted Still Images Basic Shooting SnapshotTo Remove The Shutter Sound To Protect Valuable Files available only for SD Memory CardMultiMediaCard Approximate Number of Storable ImagesTo Magnify The Stored Images Memory Card Recording Memory Card PlaybackAuto Playback Viewing File InformationIndex Playback Removing On-Screen DisplayAdvanced Features Protecting Files Deleting FilesTo Remove Protection To Reset The Setting Setting Print Information Dpof SettingDubbing Still Images Recorded On a Tape To a Memory Card To Print ALL Still Images ONE Print for EachInitialising a Memory Card To Reset The No. Of PrintsMaking a New Folder Folder and File namesProgramme AE With Special Effects Night-ScopeFade/Wipe Effects Snapshot For Tape Recording Snapshot Mode SelectionSnapshot Recording Auto FocusExposure Control Manual FocusTo Return To Automatic Exposure Control To Brighten The Subject QuicklyWhite Balance Adjustment Iris LockManual White Balance Operation Program AE WIPE/FADERExposure BalanceManual Camera Display SystemDSC For Playback MenuVideo Playback Sound Video DisplayDisplay Bright , DATE/TIME , Time CodeTo Use This Camcorder As a Player Dubbing To Or From a VCRTo Use This Camcorder As a Recorder GR-D70 only DubbingTo Use This Camcorder As a Recorder GR-D70 only Video unit equipped with DV connectorTo DV @ Core filter DV cable Optional Core filter To DVSlow-Motion Playback Using the Remote Control UnitFrame-By-Frame Playback Playback Special EffectsAudio Dubbing Set 12BIT Mode to Sound 2 or MIX Menu Screen  pgInsert Editing To hear the dubbed sound during playbackRandom Assemble Editing R.A.Edit SET REMOTE/VCR CodeMake Connections Select Scenes Automatic Editing to VCR Adjustment of VCR/CAMCORDER TimingFor More Accurate Editing Diagnosing VCR/CAMCORDER TimingUsing DV cable Using USB cableUsing USB cable Connection To a Personal ComputerFocus does not adjust automatically No power is suppliedSnapshot mode cannot be used Image taken using Snapshot is too darkImage looks like the shutter speed is too Slow Black & White Fader does not workWhite Balance cannot be activated Date/time does not appearAn error indication E01, E02 or E06 appears Charger indicator on the camcorder does Not lightAn error indication E03 or E04 appears Memory card cannot be played backBattery Packs CassettesMemory Cards How to handle a CD-ROM LCD MonitorMain Unit Cleaning The Camcorder For Your MaintenanceAfter Use About moisture condensationAC Adapter CamcorderRemote Control Controls, Connectors And IndicatorsIndex LCD monitor Stereo Microphone Speaker pg Power Switch  pg@ Digital Video Input GR-D70 only Audio/Video Input GR-D70 only2b i t / SOUND1 LCD Monitor/Viewfinder IndicationsDuring Memory Card Recording Only 1024 During Both Tape And Memory Card RecordingAppears when the Insert Editing w or Insert Editing Appears when in the Squeeze or Cinema modeDisplays the sound mode for approx seconds after Appears when Digital Image Stabiliser DIS isAppears when the tape ends during recording or playback Appears when no tape is loadedHigh CassetteE01, E02 or E06 Unit in Safeguard Mode E03 or E04 Unit in Safeguard Mode EjectAppears if a file in another format is selected RM-V717U optional Using The Optional RM-V717U Remote Control UnitTerms See previous page as well