JVC LYT0672-001A, 1000MKV*UN*VP 14EN, Shooting While Watching LCD Monitor, To Stop Recording

14EN

	During shooting
Power Switch
Recording Start/Stop Button
2 5M I N	Tape remaining
	time indicator
	(Approximate)

MIN 60MIN 59MIN

(Now calculating)

0MIN 1MIN 2MIN 3MIN

(Blinking) (Blinking) (Blinking)

RECORDING Basic Recording

NOTE:

You should already have performed the procedures listed below. If not, do so before continuing.

●Power (
pg. 6)

●Load A Cassette (
pg. 13)

●Recording Mode Setting (
pg. 12)

●Tape Length Setting (
pg. 12)

●Grip Adjustment (
pg. 8)

●Viewfinder Adjustment (
pg. 8)

Shooting While Watching The Viewfinder

1 Make sure the LCD monitor is closed and locked. Press in the tabs on the lens cap to remove it. Set the Power Switch to “” or “ ”. The power lamp lights and the camcorder enters the Record-Standby mode. “PAUSE” is displayed in the viewfinder.

2 Press the Recording Start/Stop Button. “ ” appears

in the viewfinder while recording is in progress.

To Stop Recording . . .

.... press the Recording Start/Stop Button. The camcorder

re-enters the Record-Standby mode.

180°

BRIGHT Wheel

90°

Shooting While Watching The

LCD Monitor

1 Make sure the LCD monitor is fully open. Press in the tabs on the lens cap to remove it. Set the Power Switch to “” or “ ”. The power lamp lights and the camcorder enters the Record-Standby mode. “PAUSE” is displayed in the LCD monitor.

2 Tilt the LCD monitor upward/downward for best viewability and press the Recording Start/Stop Button. “” appears in the LCD monitor while recording is in progress.

BR I GHT – – – – – – – –6– – – +

To Adjust The Brightness Of The LCD Monitor

.... rotate BRIGHT until the bright level

indicator on the display moves and the appropriate brightness is reached.

NOTE:

When you use the LCD monitor outdoors in direct sunlight, the LCD monitor may be difficult to see. If this happens, use the viewfinder instead.

To Stop Recording . . .

.... press the Recording Start/Stop Button. The camcorder

re-enters the Record-Standby mode.

Power Switch Position

:Suitable for standard recording using NO special effects or manual adjustments.

: Allows you to set recording functions using the menus for more creative capabilities. OFF : Switches off the camcorder.

: Allows you to play back your recordings.