44EN, As necessary before you start shooting

44EN		DETAILS
	I T E M S	N O T E S

	➪ Power	❍ Perform charging where the temperature is between 10° and 35°C. 20° to
	( pg. 6)	25°C is the ideal temperature range for charging. If the environment is too
		cold, charging may be incomplete.

❍Charging times noted above are for a fully discharged battery pack.

❍Charging time varies according to the ambient temperature and the status of the battery pack.

❍To avoid interference with reception, do not use the AC Adapter near a radio.

❍Since the AC Adapter processes electricity internally, it becomes warm during use. Be sure to use it only in well-ventilated areas.

❍The following operation stops charging or discharing:

•Set the Power Switch to “ ”, “ ” or “ ”.

•Disconnect the AC adapter from the camcorder.

•Unplug the AC adapter’s power cord from the AC outlet.

•Detach the battery from the camcorder.

➪ Date/Time	❍ The date/time cannot be stored in memory if the built-in clock battery runs
Settings	out. Consult an authorized JVC dealer for replacement, or set the date/time
( pg. 9)	as necessary before you start shooting.
( pg. 9)

➪ Recording	❍ When the Power Switch is set to “ ” or “ ” and the LCD monitor is
( pg. 14, 15)	opened at an angle of 60 degrees or more, the LCD monitor switches on
	and the viewfinder switches off automatically to save power.

❍The cassette holder cannot be opened unless a power supply is attached.

❍There may be a delay after you slide EJECT until the cassette holder opens. Do not use force.

❍The time required to calculate the remaining tape length, and the accuracy of the calculation, may vary according to the type of tape used.

❍The tape remaining time indicator is correct only if the correct tape length has been selected ( pg. 12).

❍“TAPE END” appears when the tape reaches its end, and the power goes off automatically if left in this condition for 5 minutes.

“TAPE END” also appears when a cassette whose tape is already at its end is loaded.

❍If the Recording Start/Stop button is pressed after the Record-Standby mode has continued for over 5 minutes, recording may not start immediately.

❍While shooting, sound is not heard from the speaker.

➪ TBC	❍ The “TBC” indicator turns green (grey with a camcorder equipped with a
(Time Base	black/white viewfinder) while TBC is working.
Corrector)	❍ TBC does not work during still playback and shuttle search.
( pg. 31)	❍ The “TBC” indicator turns white while TBC is not operative.
	❍ It may take a few seconds before TBC actually starts working.
	❍ The picture may be distorted if the TBC mode is activated or deactivated at
	the edit-in/-out points or when normal playback resumes after still playback
	or shuttle search.
	❍ If the playback picture is distorted when TBC is set to on, turn off TBC.

44EN