(FINE adjustment can be made up to 22.5 degrees
by pressing 
or 
.)
Notes:
•When the “I” cursor reaches the “+” end, it jumps back to “−”. At the same time, COARSE is incremented by one step to enable a contin-
uous adjustment. The reverse takes place when the “I” cursor reaches the “−” end.
•When 
or 
is kept pressed for a second or longer, the “I” cursor moves faster.
•To reset COARSE and FINE to the values pre-
set at the factory, press 
or 
simultane- ously. COARSE and FINE adjustments are preset at the factory to
•If the AC line contains noise (spike noise, etc.), the stability of the vertical phase of the camera video output signal may be disturbed.
7.Motion Detector Setting (MOTION DET)
The motion detector detects the moving objects in the scene by monitoring the brightness level changes. You can select the level of sensitivity for motion detection.
When this camera is connected to a compatible intelli- gent CCTV system, the camera transmits an alarm sig- nal by multiplexing it with the video signal.
1.Move the cursor to the MOTION DET parameter and select ON.
2.Press 
. The MOTION DETECT menu appears on the monitor screen.
** CAM SET UP ** | ** MOTION DETECT ** |
| ||||
CAMERA ID | OFF | ↵ | LEVEL | ....I.... | ||
ALC/ELC |
| ALC | ↵ | |||
SHUTTER |
|
| DISPLAY MODE↵ | - | + | |
AGC |
| ON |
|
|
| |
SENS UP |
| OFF |
| ALARM | ON |
|
SYNC |
| INT |
|
| ||
MOTION DET | ON | ↵ | MASK SET ↵ |
|
| |
LENS DRIVE | DC |
|
|
| ||
END | SET UP ENABLE | RET END |
|
| ||
|
|
|
|
|
| |
3.Move the cursor to MASK SET and press 
. The MASK SET menu has 48 masks. To set MASK SET, proceed as described in steps 2 to 4 of “ALC mode with
4.Move the cursor to the ALARM parameter and select ON or OFF to set the alarm in the DISPLAY MODE.
Note: When the system controller
5.Move the cursor to DISPLAY MODE and press 
to see the current setting. The masks that detect the brightness changes start blinking.