Axis Communications P5522 Multi-Connector Cable sold separately, Function Pin Specifications

Page 57

AXIS P5522 PTZ Dome Network Camera

Multi-Connector Cable (sold separately)

Multi-Connector Cable (sold separately)

When connecting external equipment to the Axis product, a multi-connector cable (available from Axis) is required in order to maintain the product’s IP rating. The multi-connector cable can be purchased from your Axis reseller.

Connect the multi-connector cable to the product’s multi-connector. To locate the multi-connector, see Hardware Overview on page

7 . The cable provides the following connectors:

Power connector - 3-pin terminal block used for power input. See image below. Use a Safety Extra Low Voltage (SELV) compliant limited power source (LPS) with either a rated output power limited to ≤100 W or a rated output current limited to ≤5 A.

Audio in (pink) - 3.5 mm input for a mono microphone, or a line-in mono signal (left channel is used from a stereo signal).

Audio out (green) - 3.5 mm output for audio (line level) that can be connected to a public address (PA) system or an active speaker with a built-in amplifier . A stereo connector must be used for the audio out.

I/O terminal connector - Use with external devices in combination with, for example, tampering alarms, motion detection, event triggering, time lapse recording and alarm notifications. In addition to the 0 V DC reference point and power (DC output), the I/O connector provides the interface to:

Function

Pin

Notes

Specifications

0 V DC (-)

1

DC output

2

Can be used to power auxiliary equipment.

3.3 V DC

Note: This pin can only be used as power out.

Max load = 250 mA

Configurable (Input

3–6

Digital input – Connect to pin 1 to activate, or leave

0 to max 40 V DC

or Output)

floating (unconnected) to deactivate.

Digital output – Connected to pin 1 when activated,

0 to max 40 V DC, open

floating (unconnected) when deactivated. If used with

drain, 100 mA

an inductive load, e.g. a relay, a diode must be connected

in parallel with the load, for protection against voltage

transients.

Connection diagram

A I/O configured as input

57

Image 57

Contents Axis P5522 PTZ Dome Network Camera Liability About this document Legal ConsiderationsIntellectual Property Rights Equipment ModificationsLearn More SupportAxis P5522 PTZ Dome Network Camera Table of ContentsPerformance Considerations Support Advanced Reset to Factory Default SettingsSafety Information Hazard LevelsOther Message Levels Hardware Overview Network Connector Connectors and ButtonsMulti-connector For technical specifications, seeMidspan LED Indicators LED IndicatorsSD Card Slot Control ButtonAccess the Product Access from a BrowserAccess from the Internet Set Power Line Frequency Set the Root PasswordLive View Controls on the Live ViewAxis Media Control viewer toolbar Go to Setup EventsManual Trigger To show the manual trigger buttons in the Live ViewAMC Audio Controls PTZ ControlsAxis P5522 PTZ Dome Network Camera How to Stream H.264 Media StreamsAxis Media Control AMC QuickTimeTM. The following paths can be used Alternative Methods of Accessing the Video StreamJava applet supports simplex audio with G.711 encoding Access Audio StreamsBasic Setup Set Up the ProductVideo and Audio Set Up Video StreamsPixel Counter ImageClick Save to apply the new settings Stream Profiles264 Exposure Settings Camera SettingsImage Appearance White BalanceImage Settings OverlayGo to Video & Audio Video Stream and select the Image tab Overlay Image Use Overlay Text in an Action RuleGo to Video & Audio Overlay Image Privacy Mask Set Up AudioAudio Modes Go to Events Action RulesAudio Input Audio Output Audio ClipsDefault Viewer for Browsers Configure the Live ViewViewer Settings Browser Viewer DescriptionGo to Setup Live View Config User Defined LinksOutput Buttons Preset Positions PTZ Pan Tilt ZoomGatekeeper Osdi Zones Guard TourAdvanced LimitsControls Control Queue Operator Same as administrator but with lower priorityDetectors Set Up Motion Detection WindowsMotion Detection Motion Detection ParametersAudio Detection Default valuesMedium level 50% Low level 0%Go to Setup Applications Install ApplicationApplications Application LicensesAxis P5522 PTZ Dome Network Camera Events Set Up Action RulesConvert Event Types to Action Rules Go to Events Action Rules and click AddActions TriggersRecipient Types Add RecipientsPTZ Control Go to Events Recipients and click AddSet Up Email Recipients Create SchedulesGo to Events Schedules and click Add Go to Events Recurrences and click Add Set Up RecurrencesRecording List RecordingsContinuous Recording Go to Recordings ListLanguages Security System OptionsUsers IP Address FilterIeee CertificatesGo to System Options Security Ieee Click Install certificate and upload the certificate Go to Setup System Options Security CertificatesDate & Time Audio SupportNetwork Basic TCP/IP SettingsAxis Internet Dynamic DNS Service Advanced TCP/IP SettingsAxis Internet Dynamic DNS Service requires IPv4 DNS ConfigurationHost Name Configuration NTP ConfigurationLink-Local IPv4 Address NAT traversal port mapping for IPv4FTP QoS Quality of ServiceUPnPTM UPnPTM can be disabled under System Options Network UPnPTMRTP/H.264 BonjourSD Card StorageMount and Unmount SD Card Format SD CardPorts & Devices MaintenanceNetwork Share Ports Support Overview Support System Overview Logs & ReportsPlain Config Reset to Factory Default SettingsScripting File UploadAxis P5522 PTZ Dome Network Camera Cable provides the following connectors Multi-Connector Cable sold separatelyFunction Pin Specifications Drain, 100 mAConnector Upgrade the Firmware TroubleshootingEmergency Recovery Procedure Check the FirmwareProblems setting the IP address Symptoms, Possible Causes and Remedial ActionsProduct cannot be accessed from a browser Product is accessible locally but not externallyVideo and image problems, general Problems with streaming H.264Setup Video & Audio Camera Settings Key framesStorage and disk management problems SettingsNo audio Poor audio qualityTechnical Specifications Installation Function/group Specifications Network SecurityMaintenance General Casing PowerPerformance Considerations M5.2

Related manuals

Manual 56 pages 25.76 Kb