22 en Installation | FLEXIDOME HD VR |
|
|
6.Using one of the keyholes, hang the mounting base of the camera module on one screw temporarily; tilt the base slightly to gain access to the cable connections.
7.Make the connections as outlined in section 5.3 below.
5.3Connections
CAUTION!
Isolate unused power wires individually to prevent short- circuits.
Check the type label on the the camera module for the correct power ratings.
5.3.1Make the connections
Connection box
The unit has connection terminals on flying leads. In wet or outdoor installations make use of a field wiring box with NEMA Type 4X or IP66 protection level or better.
1.Make the connections inside a water tight compartment. Isolate unused power wires individually.
2.After connections are made ensure that the watertight compartment is tightly closed and cables and conduits are properly sealed to prevent ingress of water.
Installation Manual | Bosch Security Systems |