AT&T 999-507-144 system manual Considerations Administration Programming HOW to USE, Transfer

CONSIDERATIONS

ADMINISTRATION

PROGRAMMING

HOW TO USE

Personal Speed Dial uses a dialing code. You do not place these codes on a voice terminal button.

The attendant or administrator at Intercom 10 cannot use code #01.

You may need to program a pause, stop, or switchhook flash into a Personal Speed Dial sequence, or you may need to switch from rotary to Touch-Tone signals in the middle of a programmed dialing sequence. To do so, you must enter one or more of the following special characters when you program the sequence. (For more information about using special characters in a dialing sequence, see "Special Characters in Dialing Sequences.")

● TO program a pause, touch Hold.

●To program a stop, touch Drop.

●To program a switchhook flash at the beginning of a number, touch Recall and then touch Hold.

●To program Touch-Tone Enable into a dialing sequence, touch

Transfer.

None

This feature is not associated with a voice terminal button.

1Slide the T/P switch to P.

The voice terminal rings every 5 seconds to remind you that you are programming and that you cannot place or receive calls.

2Dial a Personal Speed Dial code (#01 through #22).

3Dial *90 plus a telephone number or a PBX, Centrex, or Custom Calling feature code.

4Slide the T/P switch to the center position.

To place a call using a Personal Speed Dial code:

1Lift your handset.

2Dial a Personal Speed Dial code (#01 through #22).

MERLIN Plus System Features 5-53