None
To program an Outside Auto Dial button for your voice terminal:
1 Label -the button with a name and/or a number.
2 Slide the T/P switch to P.
The voice terminal rings every 5 seconds to remind you that you are programming and that you cannot place or recieve calls.
3 Touch the button you want to program.
4 Dial *90 plus a telephone number or a PBX or Centrex code (if you need to include a special character in the dialing sequence, use the directions above).
5 Slide the T/P switch to the center position.
To program Touch-Tone Enable, touch
Transfer.
To program a switchhook flash at the beginning of a number, touch Recall and then touch Hold.

If the line is busy, or if you get no answer:

1Touch Speaker to cancel the call.

Outside Auto Dial

DESCRIPTION

CONSIDERATIONS

You can use Outside Auto Dial to dial frequently used numbers and codes with one touch. These numbers and codes can include telephone numbers, and PBX, Centrex, or Custom Calling feature codes. You can include up to 16 numbers and special characters in an Outside Auto Dial sequence.

Any time instructions tell you to dial an outside number, you can touch an Outside Auto Dial button instead if you have one programmed for the number you want to dial.

You may need to program a pause, stop, or switchhook flash into an Outside Auto Dial sequence, or you may need to switch from rotary to Touch-Tone signals in the middle of a programmed dialing sequence. To do so, you must enter one or more of the following special characters when you program the sequence. (For more information about using special characters in a dialing sequence, see "Special Characters in Dialing Squences.")

To program a pause, touch Hold.

To program a stop, touch Drop.

ADMINISTRATION

PROGRAMMING

5-50Section 5: Reference

Page 114
Image 114
AT&T 999-507-144 system manual Outside Auto Dial, Administration Programming