ADMINISTRATION

PROGRAMMING

HOW TO USE

Program

DESCRIPTION

CONSIDERATIONS

If your responsibilities do not include system administration, skip this information.

1Enter administration mode by sliding the T/P switch to P and touching

Administer.

2Dial *57.

The green light goes on next to those lines that cannot be bridged or monitored.

3If you want to change the Privacy setting of either Line A or Line E, touch the line button until the green light next to it shows the setting you

want:

Geen light on = the line is private

Green light off = the line can be monitored

4Touch Administer.

The console beeps twice.

5Leave administration mode by sliding the T/P switch to the center position.

None

N o n e

By using the Test/Program switch and following the instructions listed below, you can program features that you have selected for your voice terminal onto available buttons.

There are several programmable features that you can use with either a button or a dial code. Therefore, if you have a limited number of available feature buttons, you may choose to use a dial code rather than program any of those features onto your voice terminal.

If you make a mistake when programming a button, simply touch the button again and redial the programming code and all required numbers.

If you want to change the feature assignment on a programmable button, use the procedure listed on the next page.

5-56Section 5: Reference

Page 120
Image 120
AT&T 999-507-144 system manual Administration Programming HOW to USE