CONSIDERATIONS
ADMINISTRATION
PROGRAMMING
HOW TO USE
When the administrator resets the system, all programming done for any voice terminal in the MERLIN Plus system is erased. If the administrator has administered customized line assignments for any voice terminal, these are erased also, and the line configuration is returned to square operation.
System Reset requires readministering your system and reprogramming all voice terminals.
To reset your system to the initial feature assignments:
1Enter administration mode by sliding the T/P switch to P and touching Administer.
2Dial *99198.
The console beeps twice.
NOTE: If the console beeps only once or not at all, the reset didn't work, probably because someone was using the system when you dialed the System Reset code. Wait until no one is using the system, and try the reset again.
3Go to the control unit and turn the power off and then on again.
The red lights go on, and the green lights flash.
The console rings every five seconds.
4Leave administration mode by sliding the T/P switch to the center position.
N o n e
This feature is recommended for service personnel only.
System Speed Dial
DESCRIPTION | The administrator can store System Speed Dial codes for telephone numbers, |
| such as a warehouse number or a branch office number, and account numbers |
| that people in the office frequently use. People can then dial the number |
| simply by dialing the proper |
| Speed Dial is particularly useful when the administrator wants to give users |
| access to a specific number, for instance, an authorization code for an |
| alternate |
| For more information about assigning a System Speed Dial codes to account |
| numbers that the administrator wants to appear on call reports, see "Accout |
| Number Entry." |
