Bosch Appliances NDN-832 Power connection, Network and PoE connection, Alarm Input

FlexiDomeHD 1080p IP Camera Installation en 25

CAUTION!

Check the type label on the rear of the camera module for the correct power ratings.

Power connection

1.Use a class 2 power supply 24 VAC or +12 VDC.

2.Connect the power wires (red+ , brown-) to the power supply.

3.Connect the earth wire (yellow/green) from the camera to the system earth of the installation to ensure correct EMC/ RFI and safety protection.

Network (and PoE) connection

1.Use a shielded twisted pair (STP) Category 5e cable, maximum length 100 meters.

2.Use the RJ45 female-to-female network cable connector to connect the network cable of the system to the RJ45 connector of the camera (Auto MDIX compliant - automatically detects the cable connection type).

Power is supplied to the camera via the Ethernet cable, compliant with the Power-over-Ethernet standard.

Note:

The RJ45 female-to-female network cable connector supplied is unshielded.

To comply with the EMC Alarm immunity standard (EN50130-4) or the EMC Railway immunity standard (EN50121-4), a shielded twisted pair (STP) connection cable and a shielded RJ45 female-to-female network cable connector (not supplied) should be used.

Alarm Input

Use the alarm input to connect external alarm devices such as door contacts or sensors. A zero potential make or break

Bosch Security Systems Installation Manual AM18-Q0601 v1.0 2012.01