Bosch Appliances NDN-832 installation manual Mount the camera module, M 1 N-m

Page 27

FlexiDomeHD 1080p IP Camera

Installation en 27

 

 

5.4Mount the camera module

1.Route the cable tree from the camera around the rear of the camera module and secure all cables.

2.For surface mounted units, place the surface mount ring over the mounting base.

With a side connection, remove the tab at the side entrance; with a rear connection, leave it in place.

3.Use the fixing ring to secure the camera module to the mounting base:

Align the screws in the fixing ring with the raised holes in the mounting base.

Tighten the three screws with the supplied screwdriver bit (maximum torque 1 N-m).

> 1 N-m > 1 N-m

x3

x3

Bosch Security Systems

Installation Manual

AM18-Q0601 v1.0 2012.01

Image 27
Contents FlexiDomeHD 1080p IP Camera Page Table of Contents Maintenance InstallationCamera configuration Troubleshooting10.1 Specifications 10.1.1 Dimensions Technical DataSafety precautions SafetyImportant safety instructions Connection in applications Type labelGrounding FCC & Ices Information FCC & Ices complianceMicroSD cards UL certificationDisclaimer Bosch notices Copyrights Introduction FeaturesOverview of functions System InformationTamper detection and motion detection Alarm I/OPower-over-Ethernet AudioConfiguration EncryptionRecording Bosch Recording Station Operation with external systemsBosch Video Management System Bosch Video ClientPlanning UnpackingSystem requirements Parts InstallationSurface mounting Mounting the unitFlexiDomeHD 1080p IP Camera Installation en Figure?5.2?Flush mounting Flush mountFlexiDomeHD 1080p IP Camera Installation en Make the connections Wire colorSignal ConnectionsPower connection Alarm InputNetwork and PoE connection Audio in / Audio out Alarm outputM 1 N-m Mount the camera moduleOpening the camera module Controls Camera set-up 1 Pan Camera positioningTilt Twist Adjustment procedure Using the install wizardClosing the unit Day/Night switching Camera configurationProtected network Browser connectionFunction test TroubleshootingMalfunction Possible causes Solution Resolving problemsLivepage Functions For example 192.168.0.80/version Customer serviceData Terminal MaintenanceTesting the network connection Communication with Terminal Program192.168.0.1 Configuring the TerminalCommand Inputs Assigning an IP AddressAdditional Parameters RebootRepairs Transfer and disposalSpecifications Technical DataIP, IBP, Ibbp 10.1.1 Dimensions En Technical Data FlexiDomeHD 1080p IP Camera Page Bosch Security Systems