Bosch Appliances NDN-832 installation manual Alarm output, Audio in / Audio out

Page 26

26 en Installation

FlexiDomeHD 1080p IP Camera

 

 

contact can be used as the actuator (use a bounce-free contact system).

Refer to the cable tree table to identify the wire colors for connecting the alarm input.

Configurable as active low or active high.

Alarm output

Use the alarm relay output for switching external devices such as lamps or sirens.

Refer to the cable tree table to identify the wire colors for connecting the alarm output.

In the menu system, configure the relay output to operate as either normally open (NO) or normally closed (NC).

Audio in / Audio out

The unit has full-duplex mono audio. The two-way communication can be used to connect a speaker or door intercom system. The audio input signal is transmitted in sync. with the video signal.

Refer to the cable tree table to identify the wire colors for connecting the audio input and output.

Audio in: Line input level (not suitable for direct microphone signal).

Audio out: Line output level (not suitable for direct speaker connection).

Wiring: Shielded audio connection cable is advised.

AM18-Q0601 v1.0 2012.01

Installation Manual

Bosch Security Systems

Image 26
Contents FlexiDomeHD 1080p IP Camera Page Table of Contents Troubleshooting InstallationCamera configuration MaintenanceTechnical Data 10.1 Specifications 10.1.1 DimensionsSafety Safety precautionsImportant safety instructions Grounding Connection in applicationsType label FCC & Ices compliance FCC & Ices InformationDisclaimer MicroSD cardsUL certification Bosch notices Copyrights Features IntroductionSystem Information Overview of functionsAudio Alarm I/OPower-over-Ethernet Tamper detection and motion detectionRecording ConfigurationEncryption Bosch Video Client Operation with external systemsBosch Video Management System Bosch Recording StationSystem requirements PlanningUnpacking Installation PartsMounting the unit Surface mountingFlexiDomeHD 1080p IP Camera Installation en Flush mount Figure?5.2?Flush mountingFlexiDomeHD 1080p IP Camera Installation en Connections Wire colorSignal Make the connectionsNetwork and PoE connection Power connectionAlarm Input Alarm output Audio in / Audio outMount the camera module M 1 N-mOpening the camera module Controls Camera set-up Camera positioning 1 PanTilt Twist Using the install wizard Adjustment procedureClosing the unit Camera configuration Day/Night switchingBrowser connection Protected networkTroubleshooting Function testResolving problems Malfunction Possible causes SolutionLivepage Functions Customer service For example 192.168.0.80/versionCommunication with Terminal Program MaintenanceTesting the network connection Data TerminalAssigning an IP Address Configuring the TerminalCommand Inputs 192.168.0.1Transfer and disposal RebootRepairs Additional ParametersTechnical Data SpecificationsIP, IBP, Ibbp 10.1.1 Dimensions En Technical Data FlexiDomeHD 1080p IP Camera Page Bosch Security Systems