2. SETUP OPERATION
This camera utilizes a user setup menu (CAM SET UP) that is displayed on the monitor.
To set items on the CAM SET UP menu, use the follow- ing buttons on the side panel.
Left Button ( 
): Moves the cursor to the left. Use this button to select or adjust the parameters of the selected item.
The parameter changes each time this button is pressed.
Set Button ( 
): Executes selection and displays a submenu for an item with 
mark. END: Close Setup menu.
Left Button 
Set Switch
Up Button
Right Button
Down Button
RET: Return to the previous menu or page.
To return to the CAM SET UP menu move the cur-
sor to RET and press 
.
• All Reset Operation
Up Button ( 
): Moves the cursor upwards. Use this button to select an item or adjust the parameters.
Down Button ( 
): Moves the cursor downwards. Use this button to select an item or adjust the parameters.
Right Button ( 
): Moves the cursor to the right. Use this button to select or adjust the parameters of the selected item. The parameter changes each time this button is pressed.
All Reset allows you to reset all setup menu items to the factory settings if you are unsure about the correct set- tings. Proceed as follows:
(1)Make sure that the CAM SET UP menu is not dis- played (a camera picture is displayed).
(2)While pressing both 
and 
, press 
for a few seconds. The message ALL RESET momentari- ly appears on the monitor.
This resets all adjustments and parameters to the factory default settings.