Panasonic WV-CL924A ALC Mode with Preset on, Back Light Compensation Back Light Comp

Page 22

1.Move the cursor to the ALC/ELC parameter.

2.Select ALC or ELC.

Cautions:

1.Under bright lighting conditions such as outdoors, use an ALC type lens because the ELC control range is not wide enough under these conditions.

2.Use an ALC type lens if the following phenomena occur:

Strong smear and/or blooming on highlight objects such as spotlight or sunlight from win- dows.

Noticeable flicker in the picture and/or color rendition variations.

3.If ELC is selected, SHUTTER is not available.

Back Light Compensation (BACK LIGHT COMP)

Back light compensation is available for both the ALC and ELC modes. It eliminates strong background light- ing which makes the camera picture dark, such as a spotlight. You can select one of two modes (PRESET ON or PRESET OFF) of back light compensation.

2-1. ALC Mode with PRESET ON

In normal use, the important object in a scene is placed in the center of the monitor’s screen. In the factory setup mode, more photometric weight is given to the center of the screen (where the important object is located) than to the edge of the picture (where a bright backlight would most likely be located). In this mode, even though the backlight may vary, the object at the center of the screen can be still be clearly seen.

Note: If ELC is selected, set LEVEL according to this procedure.

 

** CAM SET UP **

CAMERA ID

OFF

ALC/ELC

ALC

SHUTTER

OFF

 

AGC

 

ON (DNR-H)

SENS

UP

OFF

 

SYNC

 

INT

 

WHITE BAL

ATW1

MOTION DET

OFF

 

LENS

DRIVE

DC

 

END

SET UP ENABLE

1.Select ALC and press . The ALC CONT menu appears.

-23-

Image 22
Contents Operating Instructions Bol, within an equilateral triangle, is Contents Features PrefaceDo not attempt to disassemble the camera PrecautionsClean the CCD faceplate with care Handle the camera with careMajor Operating Controls and Their Functions WV-CL9240Gen-lock Termination Switch Hi-Z, G/L 75Ω Auto Iris Lens ConnectorFlange-back Adjusting Ring FB 1Gen-lock Input Connector GEN-LOCK3Power Cord Socket 4AC/DC Compatible Input Terminal DC 12V IN/AC 24VWV-CL920 120 V AC 60Hz ConnectionsWV-CL924 12 V DC/24 V AC AC Power Supply Recommended wire gauge sizes for 24 V AC lineInstallation of Auto Iris Lens Connector Mounting the Lens Focus or FLANGE-BACK Adjustment Installation of Camera Mounting from the topSetup Camera Setup MenuATW1 ATW2 AWC Opening the Setup Menu Press and hold down for 2 seconds or moreSetup Operation All Reset OperationEditing the CAM SET UP Menu Important NoticeTo edit the Camera ID Setting ProceduresCamera Identification Camera ID Setting To enter a blank space in the Camera IDTo erase all characters in the editing area Light Control Setting ALC/ELCTo determine the display position of the Camera ID ALC Mode with Preset on Back Light Compensation Back Light CompALC Mode with Preset OFF Blinking Shutter Speed Setting Shutter Gain Control Setting AGC ON/OFFElectronic Sensitivity Enhancement Sens UP Synchronization Setting Sync Important NoticesVBS Gen-lock Mode Extvbs Page VS Gen-lock Mode Extvs Line-lock Sync Mode LLPhase Coarse Auto-Tracing White Balance Mode ATW White Balance Setting White BALATW1 Auto Tracing White Balance Manual Fine Adjustment for AWC ATW Select AWC →Motion Detector Setting Motion DET Lens Drive Signal Selection Lens DriveSpecial Menu Special Burst BW To reset to the factory settings Prevention of Blooming and SmearSpecifications AGCPage Standard Accessories Optional Accessories Panasonic Canada Inc